OBJECTIVES This study evaluated the influence of air-particle abrasion protocols on the surface roughness (SR) of zirconia and the shear bond strength (SBS) of dual-polymerized resin cement to this ceramic. MATERIALS AND METHODS Sintered zirconia blocks (n = 115) (Lava, 3M ESPE) were embedded in acrylic resin and polished. The specimens were divided according to the 'particle type' (Al: 110 µm Al2O3; Si: 110 µm SiO2) and 'pressure' factors (2.5 or 3.5 bar) (n = 3 per group): (a) Control (no air-abrasion); (b) Al2.5; (c) Si2.5; (d) Al3.5; (e) Si3.5. SR (Ra) was measured 3-times from each specimen after 20 s of air-abrasion (distance: 10 mm) using a digital optical profilometer. Surface topography was evaluated under SEM analyses. For the SBS test, 'particle type', 'pressure' and 'thermocycling' (TC) factors were considered (n = 10; n = 10 per group): Control (no air-abrasion); Al2.5; Si2.5; Al3.5; Si3.5; ControlTC; Al2.5TC; Si2.5TC; Al3.5TC; Si3.5TC. After silane application, resin cement (Panavia F2.0) was bonded and polymerized. Specimens were thermocycled (6.000 cycles, 5-55°C) and subjected to SBS (1 mm/min). Data were analyzed using ANOVA, Tukey's and Dunnett tests (5%). RESULTS 'Particle' (p = 0.0001) and 'pressure' (p = 0.0001) factors significantly affected the SR. All protocols significantly increased the SR (Al2.5: 0.45 ± 0.02; Si2.5: 0.39 ± 0.01; Al3.5: 0.80 ± 0.01; Si3.5: 0.64 ± 0.01 µm) compared to the control group (0.16 ± 0.01 µm). For SBS, only 'particle' factor significantly affected the results (p = 0.015). The SiO2 groups presented significantly higher SBS results than Al2O3 (Al2.5: 4.78 ± 1.86; Si2.5: 7.17 ± 2.62; Al3.5: 4.97 ± 3.74; Si3.5: 9.14 ± 4.09 MPa) and the control group (3.67 ± 3.0 MPa). All TC specimens presented spontaneous debondings. SEM analysis showed that Al2O3 created damage in zirconia in the form of grooves, different from those observed with SiO2 groups. CONCLUSIONS Air-abrasion with 110 µm Al2O3 resulted in higher roughness, but air-abrasion protocols with SiO2 promoted better adhesion. AbstractObjectives. This study evaluated the influence of air-particle abrasion protocols on the surface roughness (SR) of zirconia ceramic and the adhesion of dual-polymerized resin cement to this ceramic. Material and methods. Sintered zirconia blocks (N=115) (Lava, 3M ESPE) were embedded in acrylic resin and polished. The specimens were randomly divided into the following experimental groups considering the particle type (Al: 110 µm

The objective of this study is to investigate the differences of acupuncture effect between the Zusanli (St.36) and Sanyinjiao (SP.6) points on the gastrointestinal-tract (GIT) segment performed by the bioavailability of 99mTc-sodium-pertechnetate (Na99mTcO4) in rats. Male Wistar rats (n = 21) were allocated into three groups of seven each. Group 1 was treated by acupuncture bilaterally at St.36; Group 2 at SP.6; and Group 3 was untreated (control). After 10 min of needle insertion in anesthetized rats, 0.3 mL of Na99mTcO4 (7.4 MBq) was injected via ocular-plexus. After 20 min, the exitus of animals was induced by cervical-dislocation and GIT organs isolated. However, immediately before the exitus procedure, blood was collected by cardiac-puncture for blood radio-labeling (BRL). The radioactivity uptake of the blood constituents was calculated together with the GIT organs by a well gamma counter. The percentage of injected dose per gram of tissue (%ID/g) of Na99mTcO4 was calculated for each GIT organs, while BRL was calculated in %ID. According to the one-way ANOVA, the stomach, jejunum, ileum from the treated groups (Group 1 and Group 2) had significant differences compared to the controls (Group 3). However, between the treated groups (Group 1 and Group 2), there were significant differences (P < .05) in the stomach, jejunum, ileum, cecum, transverse and rectum. In BRL analysis, Group 2 showed significant increase and decrease of the insoluble and soluble fractions of the blood cells, respectively (P < .0001). The authors suggest that St.36 may have a tendency of up-regulation effect on GIT, whereas SP.6, down-regulation effect. However, further rigorous experimental studies to examine the effectiveness of acupuncture in either acupuncture points need to be carried out.

These findings suggested that acupuncture procedures at ST.36 could modulate responses in some organs, tissues, and blood in rats. Further rigorous experimental studies to examine the effectiveness in either acupuncture therapy need to be pursued.

We study the spectrum of gluon screening masses in lattice Yang-Mills theory as a function of the lattice size, for the gauge group SU (2) and near the deconfinement temperature. We obtain values for the mass ratios consistent with predictions from universality arguments.

No abstract