No abstract

No abstract

In this work, the response of different filler loading of zinc oxide (ZnO) reinforced ultra‐high‐molecular‐weight polyethylene (UHMWPE) on mechanical, abrasive wear, and antibacterial properties were studied. Two variants of untreated ZnO‐reinforced UHMWPE (U‐ZPE) and treated ZnO‐reinforced UHMWPE (T‐ZPE) with aminoproplytriethoxysilane (APTES) were used to compare the improvement of the mechanical, abrasive wear, and antibacterial properties. The abrasive wear and friction behaviors were monitored using a pin‐on‐disc (POD) test rig with different applied loads and sliding speeds against 400‐grit size of silicon carbide (SiC) abrasive paper under dry sliding conditions. The antibacterial assessments of the composites were tested against two common human body bacteria, that is, Escherichia coli (E. coli) and Staphylococcus aureus (S. aureus). Results have shown that T‐ZPE possess higher ultimate tensile strength and elongation at break values as compared to U‐ZPE. Furthermore, the T‐ZPE have higher wear resistance compared to U‐ZPE and pure UHMWPE. The average coefficient of friction (COF) of UHMWPE was not significantly affected by the addition of both untreated and treated ZnO filler. The wear mechanisms were studied under scanning electron microscopy (SEM). Both U‐ZPE and T‐ZPE composites showed active inhibition against E. coli and S. aureus bacteria. POLYM. COMPOS., 34:1020–1032, 2013. © 2013 Society of Plastics Engineers

A comparison of the room temperature wear behaviour of untreated low alloy steel surfaces with those containing TiC powders was conducted against an alumina ball. The coefficient of friction, the wear rate and the severity of the damage on the surface were assessed. Incorporation of powders produced a hardness 2.6 times greater and a wear rate 21 times less than the untreated steel. Friction from the third body abrasion and protruding carbides of the processed steel resulted in mild wear with a steady state coefficient friction of 0.4. Both samples showed surface chemical reactivity with the environment as a result of the generation of flash temperature producing an oxide layer, which influenced wear.

No abstract