SummaryIn this paper, a digital sinusoidal pulse width modulation (DSPWM) multilevel technique of 27-levels based on field programmable gate array (FPGA) is introduced, as an alternative to control of the direct current/alternating current multilevel power converters. The implementation of this technique with an FPGA XC3S500E model is achieved in the Xilinx Spartan-3E FPGA platforms. An experimental prototype is implemented by 3-cascaded H-bridges controlled by the DSPWM multilevel technique, generating high efficiency, low cost, and lower harmonic content. The efficiency of the DSPWM multilevel technique using R, RL, RC, and RLC loads connected to the power network is verified.

In this paper, the active front-end (AFE) converter topology for the total harmonic distortion (THD) reduction in a wind energy system (WES) is used. A higher THD results in serious pulsations in the wind turbine (WT) output power and several power losses at the WES. The AFE converter topology improves the capability, efficiency, and reliability in the energy conversion devices; by modifying a conventional back-to-back converter, from using a single voltage source converter (VSC) to use pVSC connected in parallel, the AFE converter is generated. The THD reduction is achieved by applying a different phase shift angle at the carrier of digital sinusoidal pulse width modulation (DSPWM) switching signals of each VSC. To verify the functionality of the proposed methodology, the WES simulation in Matlab-Simulink® (Matlab r2015b, Mathworks, Natick, MA, USA) is analyzed, and the experimental laboratory tests using the concept of rapid control prototyping (RCP) and the real-time simulator Opal-RT Technologies (Montreal, QC, Canada) is achieved. The obtained results show a type-4 WT with a total output power of 6 MVA, generating a THD reduction up to 5.5 times of the total WES current output by Fourier series expansion.

No abstract

The Active Front-End (AFE) converter topology is generated by modifying a conventional back-to-back converter, from using a single VSC to use pVCS connected in parallel. The AFE configuration improves the capability, efficiency and reliability of energy conversion devices connected to the power system. In this paper, a novel technique to reduce the total harmonic distortion (THD) in an AFE converter topology is proposed and analyzed. The THD reduction is achieved by applying a phase shift angle in the SPWM switching signals of each AFE converter VSC. To verify the functionality and robustness of the proposed methodology, the power system simulation in Matlab-Simulink is analyzed for a type-4 wind turbine converter with total power output of 9MW. The obtained simulation results show a THD reduction up to 2.5 for AFE connected to the power network.