We describe a dispersive Faraday optical probe of atomic spin which performs a weak measurement of spin projection of a quantum gas continuously for more than one second. To date focusing bright far-off-resonance probes onto quantum gases has proved invasive, due to strong scalar and vector light shifts exerting dipole and Stern-Gerlach forces. We show that tuning the probe near the magiczero wavelength at 790 nm between the fine-structure doublet of 87 Rb cancels the scalar light shift, and careful control of polarization eliminates the vector light shift. Faraday rotations due to each fine-structure line reinforce at this wavelength, enhancing the signal-to-noise ratio for a fixed rate of probe-induced decoherence. Using this minimally-invasive spin probe we perform microscale atomic magnetometry at high temporal resolution. Spectrogram analysis of the Larmor precession signal of a single spinor Bose-Einstein condensate measures a time-varying magnetic field strength with 1 µG accuracy every 5 ms; or equivalently makes > 200 successive measurements each at 10 pT/ √ Hz sensitivity.

No abstract

No abstract

The scope of the standard ISO 22975-3:2014 is the determination of the long term behavior and service life of selective solar absorbers for use in vented flat plate collectors used in typical solar domestic hot water systems or combisystems. With this scope, this standard can be the basis for the certification of solar absorbers in the framework of Solar Keymark European Certification Scheme. Measurements of optical properties are fundamental to support this certification. Six test laboratories participated in a Round Robin test for the measurement of solar absorptance and thermal emittance of different absorber coatings. The samples used were one PVD coating and two selective paint coatings all on aluminum substrates.The results were submitted anonymously and were analyzed according to standard ISO 13528:2015. The results obtained showed good agreement among the measurements made by the participants and allowed the preparation of guidelines to guarantee quality of the measurements of optical properties of solar absorbers.A proposal to include absorber coatings in the Solar Keymark certification scheme was prepared.