This article discussed the compound impact-abrasive wear behavior of shots impeller pair in shot blast cleaning. The shots impeller pairs were fabricated by investment casting processing. The predominance and shortcoming of investment casting for high chromium wear resistance materials used in shot blasting machine were also analyzed. Using investment casting technology, the high-Cr iron casting would be improvement in interal and explicit quality. And, owing to different included angles of shots, the blade show different wear behavior. The ideal included angle of shots is 12o. Increase in the angles leads to decreases of the wear resistance.

Al2O3-TiC/Al2O3-TiC-CaF2laminated ceramic drawing die used for drawing experiment was prepared by vacuum hot pressing method. The finite element models of 45#-steel and wire drawing die were built by SolidWorks and simulation analysis of drawing process were done by FEM simulation software. The axial stress, strain distribution and drawing force during deformation were got. The microstructure of the worn drawing die was observed by scanning electron microscopy (SEM) and the composition was investigated by energy dispersive X-Ray spectroscopy (EDS). Results show that the wear conditions of Al2O3-TiC-CaF2material layers were serious than Al2O3-TiC. And because of the dragging effect, solid lubricating films formed in Al2O3-TiC-CaF2material layers covered on Al2O3-TiC material layers. The drawing die owes self-lubricating performance. Without considering friction effective on invariable zone of the drawing die, the simulation result of drawing force was smaller than the measurement value.