This research work has presented the application of distributed generation (DG) units in a simultaneous placement approach on IEEE 33 radial test systems for validation of the technique with further implementation on 56-Bus Hayin Rigasa feeder. The genetic algorithm (GA) is employed in obtaining the optimal sizes and load loss sensitivity index for locations of the DGs for entire active and reactive power loss reduction. The voltage profile index is computed for each bus of the networks to ascertain the weakest voltage bus of the network before and after DG and circuit breaker allocation. The simultaneous placement approach of the DGs is tested with the IEEE 33-bus test networks and Hayin Rigasa feeder network and the results obtained are confirmed by comparing with the results gotten from separate DGs allocation on the networks. For IEEE 33-bus system, the simultaneous allocation of DGs and of optimal sizes 750 kW, 800 kW and at locations of buses 2 and 6 respectively, lead to a 66.49 % and 68.64 % drop in active and reactive power loss and 3.02 % improvement in voltage profile. For the 56-bus Hayin Rigasa network in Kaduna distribution network, the simultaneous placement of DGs of sizes 1,470 kW and 1490 kW at locations of bus 16 and 23 respectively, lead to a 79.54 % and 73.98 % drop in active and reactive power loss and 15.94 % improvement in voltage profile. From results comparison, it is evident that the allocation of DGs using the combination GA and load loss sensitivity index, gives an improved performance in relations to power loss reduction and voltage profile improvements of networks when compared to without DGs.