High-gravity brewing, which can decrease production costs by increasing brewery yields, has become an attractive alternative to traditional brewing methods. However, as higher sugar concentration is required, the yeast is exposed to various stresses during fermentation. We evaluated the influence of high-gravity brewing on the fermentation performance of the brewer's yeast under model brewing conditions. The lager brewer's strain Weihenstephan 34/70 strain was characterized at three different gravities by adding either glucose or maltose syrups to the basic wort. We observed that increased gravity resulted in a lower specific growth rate, a longer lag phase before initiation of ethanol production, incomplete sugar utilization, and an increase in the concentrations of ethyl acetate and isoamyl acetate in the final beer. Increasing the gravity by adding maltose syrup as opposed to glucose syrup resulted in more balanced fermentation performance in terms of higher cell numbers, respectively, higher wort fermentability and a more favorable flavor profile of the final beer. Our study underlines the effects of the various stress factors on brewer's yeast metabolism and the influence of the type of sugar syrups on the fermentation performance and the flavor profile of the final beer.

Response surface methodology was used to investigate the influence of the three malting parameters, i.e. degree of steeping, germination time, and temperature on the quality of proso millet malt. Each predictor variable was tested at three levels. Germination times varied from 5, 6, and 7 days, degrees of steeping were 44, 48, and 52%, and germination temperatures were 16, 20, and 24°C. A set kilning temperature of 65°C was used for all malts. A series of malt quality parameters were investigated including extract, apparent attenuation limit, gelatinisation temperature, ␣-amylase activity, ␤-amylase activity, limit dextrinase activity, Kolbach index, ␣-amino nitrogen, viscosity, and colour. The optimal malting program was achieved after the fifth day of germination, 44% degree of steeping, and a 22°C steeping and germination temperature. The obtained values for the amylolytic and cytolytic attributes were 64.8% extract, 1.383 mPa × s viscosity, 76.0% apparent attenuation limit, 111 U /g ␣-amylase activity, and 102 U /g ␤-amylase activity.

Two black rice varieties, "black non-waxy" and "black waxy", were investigated as possible raw materials for the production of malt. The malting conditions were optimised using response surface methodology. The three process parameters were steeping, germination time and temperature. Each parameter was tested at three levels: adjustment degrees of steeping were 38, 41, and 44%, germination times were 6, 7, and 8 days, and the temperatures were 20, 25 and 30°C. At the end of the germination process, all samples were kilned at 50°C for 24 h, and shoot/rootlets were removed before a detailed quality assessment was performed. Data analysis was performed using the Design Expert Statistic Program. The optimal conditions found for both rice varieties were as follows: germination time of 8 days at 30°C and 44% grain moisture. Although the extract yield, and α-amylase and β-amylase activities of both rice malts were lower than barley malt, the higher activity of limit-dextrinase enzyme and apparent attenuation limit (AAL), which was higher than 80%, suggests that rice malt has potential for use in brewing.

Scanning electron microscopy (SEM) and confocal scanning laser microscopy (CLSM) were used to investigate the microstructural changes in the endosperm during the malting process. SEM was a suitable tool to characterise the microstructural constitution of starch granules in proso millet and the changes occurring during malting. An early visible degradation (after 24 h) of starch granules located in the floury endosperm, which is close to the embryo, could be observed. Due to this degradation, using confocal scanning laser microscopy, a less dense packaging of this part of the endosperm was observed. Degradation of starch granules in the vitreous endosperm was obvious at a distinct later stage of malting (78 h) and a preferred attack of small granules (<2.5 µm) was detected. Changes in protein structure could not be detected by either SEM or CLSM.