Direct analysis in real time (DART) is an ion source that permits rapid mass spectrometric detection of gases, liquids, and solids in open air under ambient conditions. It is a unique technology in the field of chemical weapons detectors in that it does not require a vapor pressure, does not require sample preparation, and is nondestructive to the original sample. While the DART technique has had success as a first line instrument of detection, there have been lingering doubts over the technique's quantitative reliability and reproducibility. Here, we demonstrate its capability to produce linear calibration curves (R(2) = 0.99 or better) for the nerve agents GA, GB, and VX as well as the blister agent HD. Independently prepared check standards measured against these curves typically have recovery errors less than 3%. We show the DART instrument response to be linear over roughly 3 orders of magnitude. Furthermore, this study shows that averaging as few as three measurements for each data point is sufficient to produce high quality calibration curves, thus reducing data collection time and providing quicker results.

The growing use of explosives by terrorists and criminals creates a need for instrumentation which can rapidly analyze these energetic compounds, preferably on site. Direct analysis in real time (DART) is a promising technology for surface analysis with little or no sample preparation. Therefore, DART ionization is evaluated for use in detecting explosives on solid substrates and in liquid matrices. Fifteen explosives were chosen as a consequence of their common usage. Five surfaces were chosen to represent a wide range of physical properties such as composition, porosity, surface morphology, and thermal and electrical conductivity. Additionally these surfaces are commonly found in everyday surroundings. All 75 compound‐surface combinations produced a clear, easily identifiable, mass spectra characteristic of the targeted analyte. Simultaneous detection of five explosives is demonstrated on these same surfaces. Lastly, rapid detection of trace contamination in common fluids is also explored.

Paper spray ionization coupled to a high resolution tandem mass spectrometer (a quadrupole orbitrap) was used to identify and quantitate chemical warfare agent (CWA) simulants and their hydrolysis products in blood and urine. Three CWA simulants, dimethyl methylphosphonate (DMMP), trimethyl phosphate (TMP), and diisopropyl methylphosphonate (DIMP), and their isotopically labeled standards were analyzed in human whole blood and urine. Calibration curves were generated and tested with continuing calibration verification standards. Limits of detection for these three compounds were in the low ng mLrange for the direct analysis of both blood and urine samples. Five CWA hydrolysis products, ethyl methylphosphonic acid (EMPA), isopropyl methylphosphonic acid (IMPA), isobutyl methylphosphonic acid (iBuMPA), cyclohexyl methylphosphonic acid (CHMPA), and pinacolyl methylphosphonic acid (PinMPA), were also analyzed. Calibration curves were generated in both positive and negative ion modes. Limits of detection in the negative ion mode ranged from 0.36 ng mL −1 to 1.25 ng mL −1 in both blood and urine for the hydrolysis products. These levels were well below those found in victims of the Tokyo subway attack of 2 to 135 ng mL. 1 Improved stability and robustness of the paper spray technique in the negative ion mode was achieved by the addition of chlorinated solvents. These applications demonstrate that paper spray mass spectrometry (PS-MS) can be used for rapid, sample preparation-free detection of chemical warfare agents and their hydrolysis products at physiologically relevant concentrations in biological samples.

Biotoxin activity assays typically involve multistep sample preparation, multicomponent reactions, multistep analysis, or a combination thereof. We report a single-step, real-time ricin activity assay that requires little or no sample preparation and employs direct analysis in real time mass spectrometry. The release of adenine from the inhomogeneous substrate herring sperm DNA by ricin was determined to be 53 +/- 2 pmol adenine per picomole of ricin per hour. This procedure can be readily adapted to any enzyme for which a reactant or product of low molecular weight (up to approximately 600) can be identified.