-The characteristics of an induction motor vary with the number of parameters and the performance relationship between the parameters also is implicit. In case of the induction motor design, we generally should estimate many objective physical quantities in the optimization procedure. In this article, the multi objective design optimization based on genetic algorithm is applied for the three phase induction motor. The efficiency, starting torque, and material cost are selected for the objectives. The validity of the design results is also clarified by comparison between calculated results and measured ones
This paper investigates the mechanical cutting effect on the performance of induction motors. Numerical modeling of cutting effect is described in this paper. The approach inverts the degradation of the permeability model for inclusion of it into magnetic vector potential formula by Newton method. The effect of cutting on iron losses is implemented in finite element simulation. The simulation results are compared with experimental results of prototype IE4 efficiency induction motors rated at 2.2 kW. One of them was manufactured with annealed electrical steel lamination to highlight the cutting effect on the performance of the motor. The notable effect of cutting was measured in increased stator current; however, negligible differences were found in measured iron losses. The presented model in this paper follows the measurements.
-The concentrated winding configurations offer significant advantage for reducing end windings. These machines are generally used in low speed high torque application due to relatively low copper loss. However, numbers of fractional slot construction make the designer hard to properly choose pole and slot numbers for the certain application. This paper provides the general information of possible fractional slot concentrated double layer winding machine.
Since line-start synchronous permanent magnet motors (LSPMs) entered the market, they have attracted research interest toward counterpart induction motors of low power-ratings. This paper reports an investigation of line-start synchronous reluctance motors (LS-SynRMs). LS-SynRMs has not been investigated as much as LSPMs have. A motor needs to maximize rotor saliency to achieve high efficiency and a high power-factor. This results in complicated rotor geometry because the rotor cage and multiple flux barriers share the same rotor space. This paper provides an approximate method based on steady state torque analysis by which to estimate the critical inertia of a LS-SynRM. A finite element analysis (FEA)-aided analytical approach to the approximation of steady state torque is proposed to replace the more typical approach based on equivalent circuit parameters. The critical inertia resulting from the proposed method is compared to the results obtained using the FEA.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.