The effect of production parameters for electron-beam deposition of two-layer metal − ceramic coatings in one production cycle on the structure and phase composition of the outer ceramic layer based on zirconium oxide stabilized with yttrium oxide is studied. It is shown that it is possible to obtain metal − ceramic coatings with the required functional properties in one production cycle.Two-layer protective metal − ceramic coatings are used extensively in engine building in order to protect gas turbine blades [1][2][3]. It is well known [1] that in order to deposit the inner metal layer there is use of MCrAlY (where M is nickel, cobalt, iron), and for the outer ceramic layer there is use of zirconium dioxide ZrO 2 stabilized with yttrium oxide Y 2 O 3 (Yttrium Stabilized Zirconium Oxide, YSZ). The life of blades with this two-layer coating is governed to a considerable extent by deposition parameters. In spite of the extensive results of research devoted to this question [1][2][3][4][5][6][7] there are no published clear recommendations for deposition of these coatings.Normally two-stage technology is used in order to form two-layer metal − ceramic coating on turbine blades. The inner metal layer is applied to an article by means of vacuum plasma spray (VPS); air plasma spray (APS) or electron-beam physical vapor deposition (EB-PVD). A method used in the production cycle for two-layer coating deposition is shot-blasting treatment of the surface of the metal layer followed by annealing in a vacuum furnace with the aim of "healing" structural defects in the deposited layer [3]. Sometimes in order to obtain the required roughness before deposition of the outer ceramic layer the surface of the inner metal layer is subjected to hydraulic-abrasive treatment by a water emulsion of clay [4] and only then is the outer layer applied by one of the methods mentioned.Until recently in the economically developed European countries and the USA the preferred method for applying metal − ceramic protective coatings has remained plasma deposition. In some of the leading engine building firms of the world, in particular "Pratt and Whitney," there is use of a combined method for preparing two-layer coatings. The inner MCrAlY coating is applied by plasma deposition and the outer ceramic layer is applied by electronbeam deposition. Use of different equipment complicates the production process and makes it more expensive. A fundamental solution of the problem is deposition of a two-layer metal − ceramic coating in one type of equipment in one production cycle. We note that the effect of using two-layer metal − ceramic coatings depends to a considerable degree on the perfection of the production processes. It is considered [1][2][3]8] that the electron-beam method for depositing the outer ceramic layer has certain advantages compared with plasma deposition, i.e. increased cyclic endurance in thermal cycling for the ceramic layer obtained.Scientific-Production Enterprise "GEKONT," Vinnitsa, Ukraine.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.