No abstract

Purpose The purposes of this paper are to study the characterization of drill bit breakage in printed circuit board (PCB) drilling process based on high-speed video analysis and to provide an important reference for micro drill bit breakage prediction. Design/methodology/approach Based on PCB drilling experiment, the high-speed camera was used to observe the micro drill breakage process and the chip removal process. The variation of chip in the drilling process was studied and one of the key reasons for the drill bit breakage was analysed. Finally, the swing angles’ feature during the breakage process of the micro drill was analysed and researched with the image processing tools of MATLAB. Findings The micro drill was prone to breakage mainly because of the blocked chips. The breakage process of the micro drill can be divided into the stage of stable chips evacuation, the stage of blocked chips and the stage of drill bit breakage. The radians of swing angles were basically in the range of ±0.01 when the drilling possess is normal. But when the radians of swing angles considerably exceeded the range of ±0.01, the micro drill bit may be fractured. Originality/value This paper presented the method to study the characterization of drill bit breakage in the PCB drilling process by using high-speed video analysis technology. Meanwhile, an effective suggestion about monitoring the radians of swing angles to predict the breakage of micro drill bit was also provided.

No abstract

Purpose The purpose of this paper is to study and obtain the influence of resin and filler properties of printed circuit board (PCB) on the drilling force during micro drilling. Design/methodology/approach Experiments were carried out to study the influence of PCB on micro-hole drilling force under high spindle speed. A drilling force measurement system was applied, and then, the influence of resin and filler properties of PCBs on the force was analyzed. The proportion of resin and filler in the PCB was defined as four levels, and the influence of PCBs based on the drilling force measurement was summarized. Findings The drilling force decreased with the decrease in the feed rate, and lower filler (16-30 per cent) and average resin (31-50 per cent) would have a positive impact on the drilling force. At the same time, the size of uniform and fine fillers would help to reduce the drilling force. Originality/value The drilling force measurement system was applied, and the influence of PCBs on force was analyzed, which could provide a reference value on the optimization of the drilling force during micro drilling.