The Late Paleozoic is considered to be an important stage in the evolution of the Central Asian Orogenic Belt (CAOB). The Bogda Mountains, a northeastern branch of the Tianshan Mountains, record the complete Paleozoic history of the Tianshan orogenic belt. The tectonic and sedimentary evolution of the west Bogda area and the timing of initial uplift of the West Bogda Mountains were investigated based on detailed sedimentological study of outcrops, including lithology, sedimentary structures, rock and isotopic compositions and paleocurrent directions. At the end of the Early Permian, the West Bogda Trough was closed and an island arc was formed. The sedimentary and subsidence center of the Middle Permian inherited that of the Early Permian. The west Bogda area became an inherited catchment area, and developed a widespread shallow, deep and then shallow lacustrine succession during the Mid-Permian. At the end of the Mid-Permian, strong intracontinental collision caused the initial uplift of the West Bogda Mountains. Sedimentological evidence further confirmed that the West Bogda Mountains was a rift basin in the Carboniferous-Early Permian, and subsequently entered the Late Paleozoic large-scale intracontinental orogeny in the region.

In the calibration process of the positioner, in order to obtain the accurate angular position information of each axis of the turntable, it is necessary to test the rotation accuracy of the turntable higher than the accuracy of the target gyroscope, in order to achieve the test and calibration of the positioner. Therefore, this paper uses the non-magnetic technology to carry out research on the pointing accuracy and motion control of the turntable. At the same time, the influence of grating installation error on precision detection is analysed. The influence of steady-state error of turntable on the motion accuracy of turntable is analysed. Finally, the influence of servo control parameters on the dynamic performance of turntable and the influence on steady-state error are analysed. The test of the corner positioning accuracy of the turntable is carried out. The positioning accuracy and motion control parameters of the two-axis precision non-magnetic turntable are obtained, and the PID adjustment is introduced to make the accuracy index of the non-magnetic turntable meet the requirements. The turntable can realize a non-magnetic working environment and can achieve the high precision required by the index under the driving of the ultrasonic motor.