No abstract

A study was done on the tailored neutron energy spectra of (241)Am-Be neutron source due to the effect of moderators. The (241)Am-Be laboratory neutron source was used as the basic source and the emitted spectrum was modified using various neutron moderators. The various moderators used are high-density polythene, light water, heavy water, graphite, (56)Fe, BeO, Be, (6)Li and (7)Li. The absolute energy spectra and fluences in each case are calculated by using the Monte Carlo code FLUKA. This paper describes the simulation work done to design a moderated (241)Am-Be neutron source to produce various energy neutron spectra.

A single stage vacuum-type proton recoil neutron telescope (PRT) was used for accurate measurement of 14.57 MeV neutron fluence rate from an indigenously developed D-T neutron generator at Purnima, BARC. The telescope consists of a polyethylene radiator having 4 cm diameter and CsI (Tl) scintillation crystal having thickness 1.5 mm and 4 cm diameter separated by 20.5 cm kept in a vacuum chamber. The neutron detection efficiency of the telescope for 14.57 MeV neutrons was calculated analytically using n-p scattering cross section data from Evaluated Nuclear Data File VII and also evaluated using fluka simulation. The relativistic transformation of n-p differential scattering cross section from centre-of-mass to laboratory system was used for calculating the efficiency of PRT. The 14.57 MeV neutron fluence rate was also measured using copper foils. The comparison of fluence rate measured using PRT and copper foil activation techniques is presented in this paper. The total uncertainty in measurement using PRT and copper foil activation technique is found to be 3.93 and 6.97%, respectively.

A convenient neutron source is made for calibration of neutron survey instruments and personal dosimeters that are used in various nuclear installations such as fuel reprocessing, waste management, fuel fabrication and oil and well logging facilities, etc. This source consists of a bare (241)Am-Be neutron source placed at the centre of a 15-cm radius stainless steel spherical shell filled with distilled water. This paper describes the standardisation of the source at Bhabha Atomic Research Centre, using De Pangher neutron long counter both experimentally and using the Monte Carlo simulation. The ratio of neutron yield of water moderated to the bare (241)Am-Be neutron source was found to be 0.573. From the simulation, the neutron-fluence-weighted average energy of water-moderated (241)Am-Be source (fluence-weighted average energy of 2.25 MeV, dose-weighted average energy of 3.55 MeV) was found to be nearly the same as that of a (252)Cf source (fluence-weighted average energy of 2.1 MeV, dose-weighted average energy of 2.3 MeV). This source can be used for calibration in addition to (252)Cf, to study the variation in response of neutron monitoring instruments.

No abstract