Phase behavior was investigated for water/supercritical CO 2 (W/scCO2) microemulsions stabilized with sodium bis(1H,1H,2H,2H-heptadecafluorodecyl)-2-sulfosuccinate (8FS(EO) 2) mixed with various guest surfactants. Only for the mixtures with fluorocarbon-hydrocarbon hybrid anionic surfactants (FC6-HC n), the maximum water-to-surfactant molar ratio (W0(c)) was larger than that estimated from linear interpolation of the W0(c) values for pure 8FS(EO) 2 and pure guest surfactant. Fourier transform infrared (FT-IR) measurement for the microemulsion revealed that the mixing of 8FS(EO) 2 with FC6-HC n can prevent a phase transition from the microemulsion to the liquid crystal even in the presence of excess water. It was also found from the measurement of water/scCO 2 interfacial tension that the area occupied per surfactant molecule was markedly increased by the mixing with FC6-HC n. The loose molecular packing, probably due to a microsegregation of 8FS(EO) 2 and FC6-HC n, is consistent with the enhanced stability of the microemulsion upon surfactant mixing.

Fourier transform infrared (FT-IR) spectrum of water-in-supercritical CO(2) microemulsion was measured at 60 degrees C and 30.0 MPa over a wide range of water/CO(2) ratio from 0.0 to 1.2 wt % to study the distribution of water into CO(2), interfacial area around surfactant headgroup, and core water pool. The microemulsion was stabilized by sodium bis(1H,1H,2H, 2H-heptadecafluorodecyl)-2-sulfosuccinate [8FS(EO)(2)] equimolarly mixed with sodium 1-oxo-1-[4-(tridecafluorohexyl)phenyl]-2-hexanesulfonate [FC6HC4] or with poly(ethylene glycol) 2,6,8-trimethyl-4-nonyl ether [TMN-6]. The signal area of the O-H stretching band of water suggested that the number of water molecules in the microemulsion increases linearly with the water/CO(2) ratio, except for a slow initial increase below 0.4 wt % due to a part of water dissolved in CO(2). The amount of water in CO(2) was evaluated by decomposing the bending band of water into two components, one at lower frequency ascribed to water in CO(2) and the other at higher frequency to water in the microemulsion. The decomposition confirmed that CO(2) is saturated with water at the water content of 0.4 wt %. It was also revealed, from the symmetric SO stretching frequency of the surfactant, that the sulfonate headgroup is completely hydrated at the water/CO(2) ratio of 0.4-0.5 wt %. The results demonstrated that water is introduced preferentially into CO(2) and the interfacial area at small water content, and then is loaded into the micelle core after the saturation of CO(2) with water and the full hydration of the surfactant headgroup.