No abstract

In the present research, the optimum condition of the grout consisting of cement, fly ash, superplasticizer, and water was determined to produce the most durable and impermeable deep mixing columns (DMC) on silty soils. It is aimed to reduce the grout cost and environmental pollution by using high-rate fly ash in the grout. Superplasticizer additive was used to increase the flow consistency of grout consisting of high-rate fly ash. The design of the experiments was made using the 5-parameter and 4-level L16 orthogonal array table specific to the Taguchi method. Accordingly, the unconfined compression strength (qu) and the permeability coefficient (k) of the soil-binder mixtures at the end of the 7-and 28-days curing time were determined. According to the test results, regression analyzes were performed and models with high reliability were created for qu and k. As a result of optimization studies, to produce DMC having high strength and low permeability, grout content should be consisting of 14% cement, 14% fly ash (ratio of fly ash in the binder is 50%), 2.68% super plasticizer additive, and 0.95 water/binder ratio. The pozzolanic reactions in soil-binder samples with different grout contents were examined by SEM analysis.

No abstract

No abstract

The settlements occurred in building foundations depend on many soil parameters. Thus, these parameters make the solution both difficult and complex during the calculating process. Therefore, finite element programs use the subgrade reaction coefficient to facilitate the foundation solution. Two different methods, which are Winkler method and Pseudo coupled method, are used in the basic solutions with the coefficient of subgrade reaction. While the Winkler method can be solved with a single field, the pseudo method can be solved with 2 or more fields. In this study, a 10 story building with a 36 m x 36 m square foundation was separately designed on four different sand soils. Two of these soils are classified as C and the others are classified as D according to Eurocode 8. The foundation of this building built on four different soils was divided into six different areas (one region, two regions, three regions, five regions, seven regions, 10 regions). Consequently, 24 pieces analyzes were solved with ETABS programs. One of the results from these analyzes is that Winkler method is suitable for the rigid foundation. In addition, since the settlements occurred at raft foundations are small, it has been observed that both Winkler and Pseudo-coupled method are suitable for rigid foundation acceptance. Pseudo-coupled method has generally been found to be a suitable method for flexible raft foundation. In the Pseudo-coupled method, the highest settlements were obtained in the two-region solutions. An optimum number of fields was found to be 7 for Pseudo-coupled method.