When the unmanned aerial vehicle (UAV) is used for aerial spraying, the downwash airflow generated by the UAV rotor will interact with the crop canopy and form a conical vortex shape in the crop plant. The size of the vortex will directly affect the outcome of the spraying operation. Six one-way spraying were performed by the UAV in a rice field with different but random flying altitude and velocities within the optimal operational range to form different vortex patterns. The spraying reagent was clear water, which was collected by water sensitive paper (WSP), and then the WSP was analyzed to study the droplets deposition effects in different vortex states. The results showed that the formation of the vortex significantly influenced the droplet deposition. To be specific, the droplet deposition amount in the obvious-vortex (OV) state was about 1.5 times of that in the small-scale (SV) vortex state, and 7 times of that in the non-vortex (NV) state. In the OV state, the droplets mainly deposited directly below and on both sides of the route. The deposition amount, coverage rate and droplet size increased from top to bottom of the crops with the deposition amount, coverage rate, and volume median diameter (VMD) ranging 0.204–0.470 μL/cm 2 , 3.31%-7.41%, and 306–367μm, respectively. In the SV state, droplets mainly deposited in the vortex area directly below the route. The deposition amount in the downwind direction was bigger than that in the upwind direction. The maximum of deposition amount, coverage rate and droplet size were found in the middle layer of the crops, the range are 0.177–0.334μL/cm 2 , 2.71%-5.30%, 295–370μm, respectively. In the NV state, the droplet mainly performed drifting motion, and the average droplet deposition amount in the downwind non-effective region was 29.4 times of that in the upwind non-effective region and 8.7 times of the effective vortex region directly below the route. The maximum of deposition amount, coverage rate and droplet size appeared in the upper layer of the crop, the range are 0.006–0.132μL/cm 2 , 0.17%-1.82%, 120–309μm, respectively, and almost no droplet deposited in the middle and lower part of the crop. The coefficient of variation (CV) of the droplet deposition amount was less than 40% in the state of obvious-vortex and small-scale vortex, and the worst penetration appeared in the non-vortex amounting to 65.97%. This work offers a basis for improving the spraying performance of UAV.

No abstract

No abstract

Although drift is not a new issue, it deserves further attention for Unmanned Aerial Spraying Systems (UASS). The use of UASS as a spraying tool for Plant Protection Products is currently explored and applied worldwide. They boast different benefits such as reduced applicator exposure, high operating efficiency and are unconcerned by field-related constraints (ground slope, ground resistance). This review summarizes UASS characteristics, spray drift and the factors affecting UASS drift, and further research that still needs to be developed. The distinctive features of UASS comprise the existence of one or more rotors, relatively higher spraying altitude, faster-flying speed, and limited payload. This study highlights that due to most of these features, the drift of UASS may be inevitable. However, this drift could be effectively reduced by optimizing the structural layout of the rotor and spraying system, adjusting the operating parameters, and establishing a drift buffer zone. Further efforts are still necessary to better assess the drift characteristics of UASS, establish drift models from typical models, crops, and climate environments, and discuss standard methods for measuring UASS drift.

BACKGROUND: Agricultural pests and diseases affect grain yield and quality. In addition to the use of chemical agents, the biological control of diseases and insect pests has attracted more and more attention due to an urgent need for environmental protection. However, traditional operational methods do not integrate well with biological control technology. With the advantages of simple operation, low operating cost, high operating efficiency and wide application range, use of multirotor unmanned aerial vehicles (UAVs) in biological control is of great significance.RESULTS: An intelligent delivery system comprising an insect natural enemy (Trichogramma) capsule based on an M45 electric multirotor UAV was built to release Trichogramma ostriniae in corn fields under full autonomous mode. During operation, the M45 UAV can fly accurately in accordance with operational requirements; average deviation between the actual and planned routes was 0.24 m, the average flight speed was 9.18 m s −1 and the average altitude was 5.08 m. The effective coverage rate of natural enemies was 99.33% and the coverage redundancy was 36.75%. After delivery, an investigation into the field control effect showed an average control effect of 83.70%, which can result in effective pest control.CONCLUSION: A natural enemy carrier intelligent delivery system based on an M45 electric multirotor UAV was found to have good flight performance. In addition, natural enemies were evenly distributed, giving even coverage of the target fields.The system had a good control effect.