The findings show the new method to be a significant improvement in automatic glare reduction compared with earlier methods. The method is not computationally demanding, so it can in the future be evaluated clinically in high-definition endoscopic imaging systems and developed further in this environment.

In order to achieve ultra-low NOx emissions, the effects of total excess air coefficient, air coefficient in main combustion zone, blended-coal combustion and ammonia nitrogen molar ratio on a 330 MW coal-fired boiler combustion were studied by numerical simulation. The results show that the velocity field and temperature field in the furnace have synergy, the better the synergy is, the faster the temperature rises, and the more NOx it generates. Compared before and after urea spraying, the NOx concentration decreased with the decrease of the total excess air coefficient, the optimum total excess air coefficient is about 1.15, and the denitrification rate is as high as 76.2%. The smaller the air coefficient in the main combustion zone is, the smaller the NOx concentration is. The optimum air coefficient in the main combustion zone is about 0.92, and the denitrification rate is 85%. After urea injection, the denitrification rate of high volatile coal combustion is higher than that of low volatile coal combustion, and the reasonable blending mode of coal can reduce NOx emissions. The larger the ammonia-nitrogen molar ratio is, the lower the NOx concentration is. When the ammonia-nitrogen molar ratio is greater than 2, the amount of ammonia escape at the flue outlet exceeds the standard. When the ammonia-nitrogen molar ratio is less than 1, the NOx concentration at the flue outlet is greater than that before urea injection. The optimal ammonia-nitrogen molar ratio is about 2.

In the paper the measurement program of transformer winding temperature was proposed by using the fluorescence lifetime. We produced a probe to measure the temperature of the oil immersed transformer winding and used high temperature fiber to transfer fluorescence. Three methods were used to calculate the fluorescent life. By comparing advantages and disadvantages of three methods, the Prony algorithm was selected .Because it can fit multi-exponential and improve the accuracy of temperature measurement which is suitable for the fluorescence curve. At the same time, the calibration experiments of the measured temperature were carried out to achieve a real-time measurement of oil temperature.

No abstract

No abstract