Aims: The aim of the present study was to determine the effects of the tip structure of the catheters used for hemodialysis on blood recirculation at varying blood flow rates and diameters of the mock blood vessel in a well-defined in vitro experimental system, focusing on reverse connection mode. Methods: A mock circulatory circuit was created with silicon tubing (15 or 20 mm), a circulatory pump, connected through the catheter to dialysis circuit and dialyzer attached to dialysis machine. The tip of the inserted catheter was fixed to the center of the silicone tube, and 3 L of pig blood was poured into the blood side of the dialyzer and the recirculation rates were measured at blood flow rates of 100, 150, and 200 mL/min. Five types of commercially available catheters were used: (A) Argyle™, (B) Gentle Cath™ (Hardness gradient type), (C) Gentle Cath™, (D) Niagara™, and (E) Power-Trialysis®. Results: In the case of reverse connection mode, (1) the recirculation rates were lower in the catheter with a relatively large side hole (catheter C, 17%), catheters with a greater distance between the end hole and side hole (catheters C and D, 25%), and catheter with a symmetrical tip structure (catheter E, 10%) as compared with those in catheters A and B (40% and 25%); (2) increase of the blood flow rate in the dialysis machine was associated with a reduced recirculation rate; and (3) a wider inner diameter of the mock blood vessel and faster flow rate in the vessel were associated with a reduced recirculation rate. Conclusion: The lowest recirculation was observed with the catheter with symmetrical holes, which produces a helical blood flow line that does not intersect with the blood streamline flowing out to the blood supply hole.