A front-end for silicon pixel detectors in ALICE and LHCb

Dinapoli, R.; Campbell, M.; Cantatore, Eugenio; Cencelli, V. Orsolini; Heijne, E.H.M.; Jarron, P.; Lamanna, P.; O’Shea, V.; Quiquempoix, V.; Bello, David San Segundo; Snoeys, W.; Koningsveld, B. van; Wyllie, K.

doi:10.1016/s0168-9002(00)01281-x

Cited by 9 publications

(3 citation statements)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the first step of the R&D, simple diodes and full sensors with an epi-thickness of 50, 75 and 100 µm were produced. The sensors were bump bonded to the pixel front-end ASIC developed for the ALICE experiment at CERN [6] and tested, investigating in particular the response to non-ionizing energy loss [7]. The samples were exposed to total fluences of 5.13•10 13 , 1.54•10 14 and 5.13•10 14 1 MeV equivalent neutrons per cm 2 .…”

Section: The Pixel Detectorsmentioning

confidence: 99%

The PANDA MicroVertex Detector:Design and Prototype Results

Rivetti¹

2013

Proceedings of the 21st International Workshop on Vertex Detectors — PoS(Vertex 2012)

View full text Add to dashboard Cite

Section: The Pixel Detectorsmentioning

confidence: 99%

The PANDA MicroVertex Detector:Design and Prototype Results

Rivetti¹

2013

Proceedings of the 21st International Workshop on Vertex Detectors — PoS(Vertex 2012)

View full text Add to dashboard Cite

“…The signals are transmitted through this line with a frequency of 1.2 Hz. Figure 7 shows the typical readout channel circuit for the pixel detector, which is also used in the LHCb setup [13][14][15][16][17][18]. It consists of analog and digital circuits and units for adjusting parameters.…”

Section: Electronics For Signal Amplification and Shapingmentioning

confidence: 99%

Special features of detectors, electronics, and trigger system of the ALICE setup

Nikityuk

Самойлов

2012

Phys. Part. Nuclei

View full text Add to dashboard Cite

Special features and parameters of detectors, front end electronics, and trigger electronics of the ALICE setup, which is intended for investigations of ultrarelativistic nucleon-nucleon collisions at the LHC and for studies of heavy ion collisions, starting from protons to several types of ions, which have 5.5 TeV/nucleon energy in the center of mass, are described. One of the first collisions of lead ions was recorded by the ALICE detector

show abstract

“…At the boundary between two front-end chips, there are two columns of cells having dimensions of 50 × 625 µm 2 . The ALICE1 chip, as reported in [10], is a matrix of 256 × 32 cells, each occupying an area of 50 × 425 µm 2 . Both the readout logic and the local control functions are integrated on the chip.…”

Section: Description Of the Pixel Detectorsmentioning

confidence: 99%

Simulation of the response of a silicon pixel detector

Caliandro

Dinapoli

Fini

et al. 2002

Nuclear Instruments and Methods in Physics Research Section A:

View full text Add to dashboard Cite

A model to simulate the response of a silicon pixel detector is described. The effects of geometrical charge sharing, electronic noise threshold dispersion, capacitive coupling between pixel channels and δ-rays production have been taken into account. The model has been tested on the Omega3 chip, which is the direct predecessor of the ALICE pixel detector, to be used in the inner tracking system of the ALICE experiment. The model is able to reproduce the experimental data and the resulting parameters are consistent with the measurements made on the Omega3 chip.

show abstract

A front-end for silicon pixel detectors in ALICE and LHCb

Cited by 9 publications

References 6 publications

The PANDA MicroVertex Detector:Design and Prototype Results

The PANDA MicroVertex Detector:Design and Prototype Results

Special features of detectors, electronics, and trigger system of the ALICE setup

Simulation of the response of a silicon pixel detector

Contact Info

Product

Resources

About