Adsorbent Material Based on Carbon Black and Bismuth with Tunable Properties for Gold Recovery

Abstract

Adsorption recovery of precious metals on a variety of solid substrates has steadily gained increased attention in recent years. Special attention was paid to the studies on the characterization of the adsorptive properties of materials with a high affinity for gold depending on the nature of the pendant groups present in the structure of the material. The aim of the present work was to synthesize and characterize a new material by using the sol-gel synthesis method (designated as BCb/CB). In this case, synthesis involved the following precursors: bismuth carbonate (III), carbon black, and IGEPAL surfactant (octylphenoxypolyethoxyethanol). Immobilization of the heterojunction as bismuth oxide over a flexible support such as carbon black (CB) can prevent their elution in solution and make it versatile for its use in a system. In this work, a new adsorbent material based on bismuth carbonate supported over carbon black (BCb/CB) was developed and used further for gold recovery from aqueous solutions. The required material was characterized physically/chemically by scanning electron microscopy (SEM); energy dispersive X-ray spectrometry (EDX); X-ray diffraction (XRD); thermal analysis (DTG/DTA); atomic force microscopy (AFM). The Brunauer–Emmett–Teller (BET) method was used to determine the specific surface area indicating a value of approximately 40 m2/g, higher than the surface of CB precursor (36 m2/g). The adsorptive properties and the adsorption mechanism of the materials were highlighted in order to recover Au(III). For this, static adsorption studies were carried out. The parameters that influence the adsorption process were studied, namely: the pH, the contact time, the temperature, and the initial concentration of the gold ions in the used solution. In order to establish the mechanism of the adsorption process, kinetic, thermodynamic, and equilibrium studies were carried out. Experimental data proved that the gold recovery can be conducted with maximum performance at pH 3, at room temperature. Thermodynamic studies proved that the gold adsorption on BCb/CB material is a spontaneous and endothermal process. The results indicate a total adsorption capacity of 13.1 mg Au(III)/g material. By using this material in real solutions, a recovery efficiency of 90.5% was obtained, concomitant with a higher selectivity (around 95%).

A new tannin-based adsorbent synthesized for rapid and selective recovery of palladium and gold: Optimization using central composite design

“…Precious metals are widely used in various areas such as the electronic industry, production of catalysts, production of corrosion-resistant materials, and production of jewelry, due to their special physicochemical properties, including high conductivity and corrosion resistance [ [1] , [2] , [3] ]. Today inexpensive technology constantly replaces old technology, creating a huge waste stream of obsolete electronic equipment.…”

“…There are various methods such as hydrometallurgical, pyrometallurgical, solvent extraction, electrochemical extraction, adsorption with bio-sorbents, ion exchange resins, etc., to recover precious metals. Meanwhile, the adsorption technique with natural adsorbents is low cost, more straightforward, and more efficient [ [1] , [2] , [3] , 8 ].…”