An MPLS-based fat tree Network-on-Chip systems

Sllame, Azeddien M.; Salama, Nagwa

doi:10.1109/icacce.2016.8073719

Cited by 3 publications

(2 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The power optimization purely works based on number bits transitions in packet data, if there are more number of transition bits then encoding techniques is going minimize before sending the packet to next router. The generalized logical expression for encoding are given in ( 3) and (4).…”

Section: Bit Transition Encoder/decoder For Power Optimization In Nocmentioning

confidence: 99%

“…In the meantime, there are several improvements and developments in the structure of asynchronous and asynchronous NoCs [2]. Message-passing asynchronous NoC is guaranteed service over open core protocol (OCP) interfaces and is developed to a fully grown network in high speed NoC [3], [4]. The favorable services offered by the asynchronous message-passing asynchronous NoC providing guaranteed services over OCP interfaces (MANGO) are bounded services [5], [6].…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Design and performance analysis of asynchronous network on chip for streaming data transmission on FPGA

Patil,

Sandi

2024

IJRES

View full text Add to dashboard Cite

The majority of the system on chip (SoC) uses the network on chip (NoC) as routing ports for data transfer from node-to-node with minimal power consumption and low latency and high throughput. This paper concentrates on the ability to model the asynchronous NoCs on the asynchronous circuits on field programmable gate arrays (FPGAs). A 3×3 NoC and its universal asynchronous receiver transmitter (UART) protocol is designed and its simulation of the Verilog hardware description language (VHDL) code is done and tested on the Artix-7 FPGA kit, the testing processes in done using the Chipscope tool. In order to meet target requirements in terms of power consumption and latency, the label switching (LS) technique is used as routing. The proposed LS-NoC with level-encoded dual-rail (LEDR) encoding technique provides throughput by registering the packet between the different routers and it helps to improve throughput and speed. The effectiveness of the data transfer is measured and analyzed through a synthesis summary in terms of lookup table’s (LUT’s), slice registers, flip flops’s (FF’s), latency, and packet delivery ratio (PDR) for the traffic pattern generator. The proposed NoC is designed for 8×8 and each port size is 21 bits including ID’s of source and destination routers. The results can be justified by following results: improvement of LUTs is about 12%, flip-flops are 7%, improvement of throughput is 23% and delay is reduced by 26%.

show abstract

Section: Bit Transition Encoder/decoder For Power Optimization In Nocmentioning

confidence: 99%