Analysis of exterior beam-column joints under varying column axial load and code comparisons

Abstract

This paper presents a finite element (FE) study of beam-column joints subjected to cyclic loading. This study is primarily dependent on investigating the shear behavior of joints under the influence of different column axial load ratios. Wherefore, a total range of the column axial load ratios, whether in tension or compression has been considered. This paper proposes a two-dimensional (2D) FE model that considers material non-linearity. The proposed FE model was verified with experimental results from literature that tested varying column axial load ratios and different failure modes. The examination among experiential and numerical outcomes demonstrated that the FE model can reenact the conduct of beam-column joints and can catch the different failure modes with acceptable accuracy. A parametric study was established using the proposed FE model and strut-and-tie (ST) model of Pauletta to assess the Eurocode joint shear strength equations. For this purpose, four specimens were designed according to Eurocode recommendations while two other specimens were designed to satisfy all of the Eurocode recommendations except for the required joint confinement. An interaction diagram was introduced for each specimen to express the behavior under varying column axial load ratios. The results of the comparison between Eurocode, FE model, and ST model showed some differences in calculating the joint shear strength capacity, especially under column tension loads. Furthermore, this paper proposed new design equations based on Eurocode equations taking into account the column axial load effect. These proposed equations worked to increase the accuracy in calculating the joint shear strength capacity. Proposed equations were compared to the FE model results and other experimental results available in the literature. The comparison showed that the differences with the FE model decreased and that the proposed equations had better accuracy at different tension and compression loads than the Eurocode.

Modeling of Ultra-high Performance Fiber Reinforced Concrete Filled Steel Tube Columns under Eccentric Loading

“…Super-plasticizers are used to achieve great workability and self-compacting qualities despite a low water-cement ratio and provision of fiber. Several scholarships done on both its durability, overall performance, and characteristics had thus far yielded positive outcomes [15][16][17][18].…”