Analysis of system voltage profiles and harmonic filter design in the presence of time varying current injection by dynamic system models

Makram, Elham B.; Girgis, A.A.; Qiu, Jun; Pamulapati, V.

doi:10.1016/0378-7796(93)90080-x

Cited by 6 publications

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This method estimates the Z-bus matrix under specific conditions for detailed harmonic studies. Another model for dynamic non-linear loads was formed in Reference [6] using a symbolic mathematics program. Other studies on the time domain load modelling technique were presented in References [7,8].…”

Section: Introductionmentioning

confidence: 99%

A novel three‐phase time domain load modelling technique using instantaneous symmetrical components

Gül

Kaypmaz

Tanrıöven

2004

Int Trans Elec Energy Syst

View full text Add to dashboard Cite

SUMMARYThis paper presents a new time domain load modelling technique based on the method of Instantaneous Symmetrical Components (ISC) for three-phase unbalanced and distorted power system loads. ISC is used here to obtain instantaneous symmetrical voltage and current components and these components are used in the calculation of the symmetrical component model parameters, resistance (R ð0;1;2Þ ), inductance (L ð0;1;2Þ ), capacitance (C ð0;1;2Þ ) and a harmonic instantaneous current source (j ð0;1;2Þ h ðtÞ), which are all connected in parallel. The results cover four cases of the system operation and the load parameters are found for each case, even in the presence of harmonic distortion. Consequently, it is shown that the developed method is a very powerful modelling technique to model time varying, unbalanced and distorted three-phase loads, such as general loads: i.e. residential and commercial buildings.

show abstract

Section: Introductionmentioning

confidence: 99%