Application of modern measurement techniques for analysis of injection moulding shrinkage

Abstract

The process of polymer injection moulding is complex and complicated, therefore it is characterised by a number of technological and material parametersthat influence the product quality. Setting the best injection conditions requires knowledge of the processing properties of the material, mould shape and technological capacity of the injection moulding machine. Injection shrinkage, as undesirable phenomenon, causes changes of the shape and dimensions of the injection moulding; therefore, it is one of the most important problems that have to be solved, both at the phase of mould designing and at selecting the technological parameters of injection. The paper presents classification of injection moulding shrinkage as well as factors influencing the value of the shrinkage. The conducted experimental tests were related to selected topics connected with the injection process and took into account the change of the processed material characteristics (type and amount of filler) and change of certain, relatively the simplest to regulate, injecting parameters (injection time and cooling of the piece in a mould). Geometrical dimensions of the injection mouldings produced from polypropylene filled with glass fibre were measured using two methods: tactile (electronic measuring instrument) and contactless (3D scanning). The analysis of injection shrinkage illustrates that an effective influence on its value is possible by both choosing appropriate conditions of the injection within the technical range of the machine, as well as, if needed, the processing properties of material can be modified in order to obtain a moulded piece of set geometrical and strength properties. After the analysis of the results, the connection between the injection moulding shrinkage and the content of the filler and the chosen parameters of injection was established.

Application of CAX system for design and analysis of plastic parts manufactured by injection moulding

“…Today mold design requires a complex CAx system with simulation of the injection process [22][23][24]. It allows predicting of defects in early stage of the part design and their elimination [25][26][27][28].…”

The Development of UAV Airframes Made of Natural Fibers:A Review

“…There was one research that used thermoplastic material to build the drone frame kit. Thermoplastics, such as nylon, polyester, and polystyrene, are common options for commercial drones because they are inexpensive to produce into intricate parts using injection moulding techniques [22][23][24][25]. Additionally, thermoplastics are strong and lightweight, with some variations having tensile strengths above 100 MPa and densities below 2 g/cm 3 .…”

Design and construction of a sensor analytic system for the monitoring of the parameters of a plastic injection mould

“…The high performance of a plastic injection mould would facilitate quality plastic product to ensure the needs of customers and the safety requirements of plastic products are met. Tactile electronic measuring instrument and three-dimensional (3D) scanners are used to analyse shrinkages in moulded plastic parts (Jozwik et al, 2019).…”