Ball milled biochar effectively removes sulfamethoxazole and sulfapyridine antibiotics from water and wastewater

Huang, Jinhua; Zimmerman, Andrew R.; Chen, Hao; Gao, Bin

doi:10.1016/j.envpol.2019.113809

Cited by 199 publications

(68 citation statements)

References 45 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In order to prove that Fe/Ni-PG has excellent adsorption performance, the adsorption capacity of this study is compared with previously reported removal of six SAs (Table ). The data show that the adsorption capacity of Fe/Ni-PG is higher than most reported studies. ,,− ,− It is worth mentioning that the adsorption effect of Fe/Ni-PG on the six mixed SAs can be compared with some literature studies on the adsorption of SAs alone (Tables and ). It can be seen that this material is indeed a potential material for the removal of SAs.…”

Section: Results and Discussionmentioning

confidence: 82%

“…Therefore, when pH increases from 2 to 4, the adsorption capacity increases gradually. When pH > 6 (>p K a2 ), the zeta potential of Fe/Ni-PG is negative, and electrostatic repulsion exists between adsorbents and most SAs, which significantly reduces the adsorption capacity and leads to a significant decrease in q e . When pH = 8, the adsorption capacity of SPD increases, mainly because the pH is similar to the p K a2 of SPD at this time.…”

Section: Results and Discussionmentioning

confidence: 99%

See 1 more Smart Citation

Preparation of Fe/Ni Bimetallic Oxide Porous Graphene Composite Materials for Efficient Adsorption and Removal of Sulfonamides

et al. 2021

View full text Add to dashboard Cite

An iron−nickel bimetallic oxide porous graphene composite material (Fe/Ni-PG) was prepared by a simple partial combustion method, which can be used to effectively remove sulfonamides (SAs) from an aqueous solution. The adsorption performance of Fe/Ni-PG, Fe-PG, and Ni-PG on six kinds of SAs was compared, and the influence of time, temperature, pH, and initial concentration of SAs on the adsorption behavior of SAs of Fe/Ni-PG in an aqueous solution was studied. The adsorption kinetics and thermodynamics exhibited that the Langmuir model and pseudo-second-order kinetics model can describe the adsorption isotherm and kinetics. The maximum adsorption capacities of sulfadiazine (SD), sulfamerazine (SM), sulfamethazine (SDM), sulfathiazole (STZ), sulfapyridine (SPD), and sulfisoxazole (SIZ) calculated by the Langmuir model were 26.3, 50.3, 42.2, 27.3, 34.5, and 41.7 mg/g, respectively, which exceeded those of most reported adsorbents. In the adsorption process, hydrogen bonding, π−π electron donor−acceptor, electrostatic interaction, and bimetallic synergies play a major role, and the entire adsorption process is spontaneously endothermic. In addition, the material has excellent stability, and the Fe/Ni-PG after desorption is consistent with the raw material. This work provides a favorable way for the removal of SAs in the environment.

show abstract

Section: Results and Discussionmentioning

confidence: 82%

Section: Results and Discussionmentioning

confidence: 99%

Preparation of Fe/Ni Bimetallic Oxide Porous Graphene Composite Materials for Efficient Adsorption and Removal of Sulfonamides

et al. 2021

View full text Add to dashboard Cite

show abstract

“…e impact of the wastewater pH on the adsorption can be neglected since the adsorption capacities do not change when the pH is manipulated between 3 and 10. In another study, Huang et al [71] found that biochar underwent ball milling that can eliminate sulphonamide antibiotics from wastewater. e biochar was pyrolyzed at three different temperatures (300, 450, and 600 °C) for 1.5 h in a nitrogen filled tubular furnace.…”

Section: Biocharmentioning

confidence: 99%

A Review on Bamboo as an Adsorbent for Removal of Pollutants for Wastewater Treatment

Lamaming

Saalah

Rajin

et al. 2022

International Journal of Chemical Engineering

View full text Add to dashboard Cite

Water and wastewater treatment are very important for obtaining clean and sanitary water as well as protecting the environment from toxic pollutants. Not only enriched with cellulose and carbon but the abundant resources of bamboo also make it suitable to be utilized as an adsorbent. With the right processing technologies and improvements, the potential of bamboo is unlimited. This study review provides knowledge on the use of bamboo-based adsorbents for the removal of contaminants and pollutants in wastewater in the form of activated carbon, biochar, and aerogel. This review highlighted bamboo utilization and its relevance as an adsorbent for wastewater treatment. The technologies for the processing and improvement of bamboo as well as the performance of the bamboo-based adsorbents are also discussed in this study. The adsorption capacity of bamboo has shown improvement with modification and good adsorption capacity achieved with some of the adsorbent being able to be recycled and reused.

show abstract

“…Ball milling has emerged as a favorable method for the synthesis of nanomaterials and is becoming recognized as an environmentally friendly and low-cost method for enhancing the physicochemical properties of metal oxides/biochar nanomaterials [25][26][27]. The composites can be ground into nanoscale particles by ball milling, thereby increasing the specific surface area of the materials, which, in turn, enhances their adsorption capacity [28].…”

Section: Introductionmentioning

confidence: 99%

Solvent-Free Synthesis of MgO-Modified Biochars for Phosphorus Removal from Wastewater

Guo

et al. 2022

IJERPH

View full text Add to dashboard Cite

Adsorption is an efficient technology for removing phosphorus from wastewater to control eutrophication. In this work, MgO-modified biochars were synthesized by a solvent-free ball milling method and used to remove phosphorus. The MgO-modified biochars had specific surface areas 20.50–212.65 m2 g−1 and pore volume 0.024–0.567 cm3 g−1. The as-prepared 2MgO/BC-450-0.5 had phosphorus adsorption capacities of 171.54 mg g−1 at 25 °C and could remove 100% of phosphorus from livestock wastewater containing 39.51 mg L−1 phosphorus. The kinetic and isotherms studied show that the pseudo-second-order model (R2 = 0.999) and Langmuir models (R2 = 0.974) could describe the adoption process well.. The thermodynamic analysis indicated that the adsorption of phosphorus on the MgO-modified biochars adsorbent was spontaneous and endothermic. The effect of pH, FTIR spectra and XPS spectra studies indicated that the phosphorus adsorption includes a protonation process, electrostatic attraction and precipitation process. This study provides a new strategy for biochar modification via a facile mechanochemical method.

show abstract

Ball milled biochar effectively removes sulfamethoxazole and sulfapyridine antibiotics from water and wastewater

Cited by 199 publications

References 45 publications

Preparation of Fe/Ni Bimetallic Oxide Porous Graphene Composite Materials for Efficient Adsorption and Removal of Sulfonamides

Preparation of Fe/Ni Bimetallic Oxide Porous Graphene Composite Materials for Efficient Adsorption and Removal of Sulfonamides

A Review on Bamboo as an Adsorbent for Removal of Pollutants for Wastewater Treatment

Solvent-Free Synthesis of MgO-Modified Biochars for Phosphorus Removal from Wastewater

Contact Info

Product

Resources

About