Case Study of Active Filter Cake Technology Increases Oil Production Rate of Tight Reservoir and Eliminate Acid Stimulation in UAE

Abstract

An active filter cake technology (AFT) was chosen to improve production performance in the tight reservoir following a comprehensive laboratory study to determine formation damage impact caused by previous non-damaging fluids (NDF). The AFT was successfully field trialed on two wells with production improvement vs. acid stimulated offset wells. This paper discusses laboratory data and improved field productivity. It documents reduction of torque/drag with increased rate of penetration without using a lubricant during drilling. Comprehensive laboratory testing to identify origins of deficient production was completed by thoroughly reviewing drilling and completion practices, and completion type implemented. Compatibility of base brine with formation water; formation damage impact of drilling fluids used in reservoir and effectiveness of hydrochloric acid (HCl) solution pumped through coiled tubing to destroy the filter cake constituted the first phase of the investigation. Assessment of several fluids capable of mitigating concerns was performed in the second phase. The optimization and customization of candidate fluids to address all challenges was the third phase. Last phase consisted of field trials and assessment of production results. Testing identified a potential incompatibility of calcium chloride brine and the formation water. The brine was replaced with monovalent halides brine. The previous NDF system exhibited elevated filtrate volume and a high concentration of acid insoluble materials which together significantly impacted productivity. Review of the completion operation and laboratory results proved filter cakes of reservoir drill-in fluids (RDF) cannot be homogenously and entirely removed with HCl solution using coiled tubing. Only less than 50% of the wellbore length can be accessed with coiled tubing and treated with acid. The acid treatment dissolved less than 10% of filter cake when sumulated field conditions in the laboratory. Likewise, the filter cake breaker cannot be implemented on barefoot completion as its volume is totally lost to the formation after breakthrough before complete filter cake dissolution occurs. The study recommended AFT with 100% organophilic bridging materials. The AFT was successfully field trialled in two wells. Post analysis of drilling parameters with AFT exhibits lower torques without addition of lubricant compared to previous fluid along with 186% increase in average rate of penetration which saved 79 hours of ILT/well. Production kicked-off without assistance from lighter fluid (N2 gas) or stimulation showing promising results compared with near-by wells. The 100% organophilic bridging materials were used for first time in field. It proved acid stimulation can be eliminated for the tight reservoir while improving the oil production rate compared to the offset wells. In addition to inherent productivity improvement characteristics, AFT is appropriate where cheesing and greasing of RDF are common problems with lubricants. AFT demonstrates reduced torque without lubricant addition in extended horizontal deviated wells and excellent production while eliminating post stimulation.