The study is concerned with the rate of evaporation from porous rock, including the second stage of evaporation characterised by the existence of a dry surface layer separated from the wet capillary zone by a sharp evaporation front. The main objective is to investigate the relationship between the depth of evaporation front and the rate of evaporation as the drying process progresses, and to compare measured evaporation rate with the corresponding calculated values. Sandstone core samples saturated with water were allowed to dry naturally under room conditions, while the changes in the evaporation rate and the depth of evaporation front, among other quantities, were measured. We demonstrate that the evaporation rate can be very accurately determined from the depth of the evaporation front and the ambient air temperature and relative humidity using Fick’s law for water-vapor diffusion. During the second stage of evaporation, the diffusion flux through the dry surface layer is computed using the water-vapor diffusion coefficient of the rock, determined from a separate wet cup experiment. In order to cover the first stage of evaporation, an additional parameter characterising the diffusion layer of air above the surface is required, either determined by the best fit to the measured evaporation rates, or adopted from previous studies. The calculated evaporation rate was in good agreement with measurements, with Pearson correlation coefficient 0.98 and relative error of the calculations averaging 15% over the evaporation front depths ranging from 0 to 29 mm. A workflow for determining the evaporation rate from sandstone outcrops is suggested, along with possible applications in sandstone weathering research.
