Construction and optimization of polyethylene membrane with polyamides to remove pollutants and investigate their efficiency solar system

Esmaeili, Akbar; Nagadehi, S. Shirzad

doi:10.1007/s13762-020-02657-5

Cited by 3 publications

(1 citation statement)

References 41 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this scenario, California could represent a case study, being a state historically launched towards a wide use of renewable energy sources, photovoltaics in particular [ 15 , 16 , 17 , 18 , 19 ]; the above-mentioned issues were highlighted some years ago [ 20 , 21 , 22 ]. In the chart shown in Figure 1 A, it is possible to appreciate the difference between the demand for electricity and the electric power produced by photovoltaic panels in the Californian grid, in a typical spring day and depending on the various years from 2012 to 2020 [ 23 , 24 ].…”

Section: Introductionmentioning

confidence: 99%

An Overview on Anodes for Magnesium Batteries: Challenges towards a Promising Storage Solution for Renewables

et al. 2021

View full text Add to dashboard Cite

Magnesium-based batteries represent one of the successfully emerging electrochemical energy storage chemistries, mainly due to the high theoretical volumetric capacity of metallic magnesium (i.e., 3833 mAh cm−3 vs. 2046 mAh cm−3 for lithium), its low reduction potential (−2.37 V vs. SHE), abundance in the Earth’s crust (104 times higher than that of lithium) and dendrite-free behaviour when used as an anode during cycling. However, Mg deposition and dissolution processes in polar organic electrolytes lead to the formation of a passivation film bearing an insulating effect towards Mg2+ ions. Several strategies to overcome this drawback have been recently proposed, keeping as a main goal that of reducing the formation of such passivation layers and improving the magnesium-related kinetics. This manuscript offers a literature analysis on this topic, starting with a rapid overview on magnesium batteries as a feasible strategy for storing electricity coming from renewables, and then addressing the most relevant outcomes in the field of anodic materials (i.e., metallic magnesium, bismuth-, titanium- and tin-based electrodes, biphasic alloys, nanostructured metal oxides, boron clusters, graphene-based electrodes, etc.).

show abstract