Design and implementation of STATCOM for reactive power compensation and voltage fluctuation mitigation in microgrid

Chaudhari, Pushkar; Rane, Paris; Bawankar, Amit; Shete, Pranit; Kalange, Kundan; Moghe, Archit; Panda, Jyotiprakash; Kadrolkar, Aditya; Gaikwad, Kishor; Bhor, Navnath; Nikam, Vaibhav

doi:10.1109/spices.2015.7091541

Cited by 13 publications

(5 citation statements)

References 1 publication

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…In [140], STATCOM was used Power Quality in Renewable Energy Microgrids Applications with Energy Storage Technologies… DOI: http://dx.doi.org/10.5772/intechopen.98440 to mitigate voltage fluctuations at high penetration DER for microgrid applications. Furthermore, STATCOM was used to mitigate voltage fluctuation and compensate for reactive power in microgrids in [141].…”

Section: Statcom and Svcmentioning

confidence: 99%

Electric Power Conversion and Micro-Grids

2022

View full text Add to dashboard Cite

in January 2016. During his research, he gained new experiences about problems relating to high penetration levels of distributed generations and toward having 100% renewable energy in Germany, and as a result, he was awarded a fellowship program for an experienced researcher from the Alexander von Humboldt (AvH) Foundation in 2017. Currently, he is at the Cologne University of Applied Science and is involved in research on the control and dynamic investigation of interconnected micro-grids. He has published more than 120 journals and conference papers, five books, and supervised more than ten research projects. Dr. Mahdi Mansouri was born in Yazd, Iran in 1975. He received both his B.S. degree in electronic engineering and MSc degree in electronic power from the Sharif University of Technology at Power Electronics-STATCOM and his Ph.D. degree in renewable energy systems from doubly fed induction generator (DFIG)based wind turbines from the Shiraz University of Technology.He has 20 years of experience in high-voltage transmission substations and lines as a technical engineer, a consultant, and an executive project manager. His research interests include flexible alternating current transmission system devices, power quality, and power system protection. He currently conducts power electronics, power-relay protection, and power-quality projects as a consultant and project manager.

show abstract

Section: Statcom and Svcmentioning

confidence: 99%

Electric Power Conversion and Micro-Grids

2022

View full text Add to dashboard Cite

show abstract

“…In [118], STATCOM was used to mitigate voltage fluctuations in high penetration of DREs as MG. In addition, STATCOM was used for voltage fluctuation mitigation and reactive power compensation in MG in [119]. Another study showed the ability of STATCOM to reduce power fluctuation in MG and increase the voltage regulation and system power factor [29].…”

Section: B Statcom and Svcmentioning

confidence: 99%

Power Quality in Microgrids Including Supraharmonics: Issues, Standards, and Mitigations

et al. 2020

View full text Add to dashboard Cite

A microgrid (MG) is a small-scale power system with a cluster of loads and distributed generators operating together through energy management software and devices that act as a single controllable entity with respect to the grid. MG has become a key research element in smart grid and distribution power systems. MG mainly contains different renewable energy sources (RESs) that use various technological advancements, such as power electronics-based technologies. However, it has an unstable output, thereby causing different types of power quality (PQ) events. As a result, standards and mitigation methods have been developed in recent years. To mitigate PQ issues due to MG integration, various methods and standards have been proposed over the last years. Although these individual methods are well documented, a comparative overview had not been introduced so far. Thus, this study aims to fill the gap by reviewing and comparing the prior-art PQ issues, solutions, and standards in MGs. We compare the main issues related to voltage sag, voltage swell, voltage and current harmonics, system unbalances, and fluctuations to ensure high-quality MG output power. The new technologies associated with MGs generate harmonics emission in the range of 2-150 kHz, thereby causing a new phenomenon, namely, supraharmonics (SH) emission, which is not sufficiently covered in the literature. Therefore, the characteristics, causes, consequences, and measurements of SH are highlighted and analyzed. The mitigation strategies, control, and devices of PQ issues are also discussed. Moreover, a comparison is conducted between the most popular devices used to mitigate the PQ issues in MG in terms of cost, rating, and different aspects of performance. This review study can strengthen the efforts toward the mitigation and standards development of PQ issues in MG applications, especially SH. Finally, some recommendations and suggestions to improve PQ of MG, including SH, are highlighted.

show abstract

“…Benzer bir çalışma olan kömür konveyör sürücülerinin kompanzasyonu Çetin ve Ermiş tarafından [42], gerilim kaynaklı iki seviyeli eviricili DSTATCOM kullanılarak gerçekleştirilmiştir. Chang ve arkadaşları [43], Gurav ve arkadaşları [44], Escobar ve arkadaşları [45] ile Chen ve arkadaşları [46] [52], gerilim düşümünü kompanze amaçlı, Pushkar [53] ise gerilim dalgalanması için çalışmalarında iki seviyeli evirici tabanlı DSTATCOM kullanmıştır.…”

Section: İki Seviyeli Eviriciler (Two-level Inverters)unclassified

“…Bu olumsuzlukların yanı sıra verimin düşük olması, büyük transformatörlerin kullanılmasından kaynaklanan yüksek maliyet, sistemde meydana gelen toplam kayıpların yarısının bu elemanlar üzerinde oluşması, denetiminde zorluklar gibi dezavantajları da bulunmaktadır. Bu dezavantajlara rağmen literatürde belirtildiği gibi [40][41][42][43][44][45][46][47][48][49][50][51][52][53], kömür madeni makinelerinin kompanzasyonu, kömür konveyör sürücülerinin kompanzasyonu, yük kompanzasyonu, doğrusal olmayan yük kompanzasyonu, güneş tarlası, gerilim dalgalanması, gerilim düşümü kompanzasyonu uygulamalarında çözüm olarak önerilmiş ve kullanılmıştır.…”

Section: Bulgular (Findings)unclassified

Dinamik kompanzasyon cihazlarında kullanılan evirici yapıları: STATCOM ve DSTATCOM topolojileri

Dijle¹,

Ertay²,

Yücedağ³

2016

SAUFenBilDer

View full text Add to dashboard Cite

ÖZStatik Senkron Kompanzatör (STATCOM) iletim hatlarında reaktif güç kompanzasyonu ve güç sistemi kararlılığının artırılması için kullanılmaktadır. STATCOM dağıtım hatlarında kullanılırsa dağıtım STATCOM (DSTATCOM) olarak isimlendirilmektedir. Özel bir güç aygıtı olan DSTATCOM, dağıtım sistemlerinde güç kalitesi sorunlarını çözmek için kullanılan ortak kuplaj noktasına şönt bağlı bir gerilim kaynaklı eviricidir. Evirici STATCOM ve DSTATCOM'un temel yapı birimidir. Literatürde önerilen ve gerçek uygulamalarda kullanılan birçok evirici yapıları mevcuttur. Bu makalede, bugüne kadar STATCOM ve DSTATCOM'da kullanılan evirici yapıları incelenmektedir. Evirici yapılarının avantaj ve dezavantajları ortaya konulmaktadır. Ayrıca literatürden birçok örnek verilmektedir.Anahtar kelimeler: STATCOM, DSTATCOM, reaktif güç kompanzasyonu, güç kalitesi, eviricilerThe inverter structures used in dynamics compensation devices: STATCOM and DSTATCOM topologies ABSTRACT Static Synchronous Compensator (STATCOM) is used for to improve the stability of power system and reactive power compensation of transmission lines. When a STATCOM used in a distribution system it is called Distribution STATCOM (DSTATCOM). As a custom power device DSTATCOM is a shunt connected voltage source inverter to a common coupling point in the distribution system and is used for to improve the power quality problems. The main structural unit of STATCOM and DSTATCOM are inverters. Many inverter topologies are used in the application and a lot of proposed inverter structures are available in the literature. In this study the inverter structures and topologies that are used in STATCOM and DSTATCOM up to now are investigated. The advantages and disadvantages of the inverter structures are presented. Also a lot of examples from the literature have been given. *

show abstract

Design and implementation of STATCOM for reactive power compensation and voltage fluctuation mitigation in microgrid

Cited by 13 publications

References 1 publication

Electric Power Conversion and Micro-Grids

Electric Power Conversion and Micro-Grids

Power Quality in Microgrids Including Supraharmonics: Issues, Standards, and Mitigations

Dinamik kompanzasyon cihazlarında kullanılan evirici yapıları: STATCOM ve DSTATCOM topolojileri

Contact Info

Product

Resources

About