Design and testing of a magnetic suspension for a 90° horizontal bend conveyor

Abstract

Purpose -A conveyor device is studied with the aim to reduce the friction between the inner surface of the beam and the chain. The lower is the friction between the chain and the beam, the lower is the surface wear. The magnetic repulsion force among permanent magnets (PMs) placed on the beam and on the chain is utilized to reduce friction. The paper aims to discuss these issues. Design/methodology/approach -The considered magnetic suspension is realized with PMs in repulsive configuration; it is designed by solving a constrained optimization problem, with reference to the geometry of the 901 horizontal bend FlexLink WL322 conveyor. Flux density field and its gradient are evaluated using volume integral equation method, allowing to calculate the forces acting on the chain and the stiffness of the magnetic suspension. Findings -The magnetic suspension prototype was manufactured and tested. The experimental and calculated values of the forces acting on the chain compares well. A stable horizontal equilibrium of the chain was obtained during both static and dynamical tests.Research limitations/implications -The quasi-static model used neglects the dynamical interactions among the elements of the chain, the PMs and loads weight during motions and the eddy current losses in the aluminium beam. However the dynamical tests on the prototype show that the chain motion is regular up to the nominal velocity all along the conveyor with the exception of the trailing edge of the 901 curve. Practical implications -The tests on the prototype show the possibility of a removal or at least a reduction of the friction force between the chain and the inner side of the beam by means of a passive magnetic suspension. As a consequence a reduction of noise and vibrations and an increase of the mean-time-to-failure is expected. Originality/value -Prototype testing shows that the unavoidable vertical instability of the magnetic forces has no practical consequence since, reducing the allowed vertical gap, the chain is stabilized by the gravitational force.

Noise in Load Cell Signal in an Automatic Weighing System Based on a Belt Conveyor

“…The belt conveyor is used for automatic weighing to continuously feed products under measurement [8][9][10][11][12]. However the horizontal and rotational movements of belt conveyor eventually cause vibration [13], and these behave as noise source to the output of load cell sensor [14,15]. High signal-to-noise ratio (SNR) is needed to improve accuracy and resolution of weighing machine; thus noise reduction is essential process [16][17][18][19].…”