Disorders of executive functioning.

Suchy, Yana

doi:10.1037/0000307-009

Cited by 1 publication

(3 citation statements)

References 143 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This work followed the general design equations suggested in the literature. To design the drawing die process, the equations from 1 to 8 should be followed [28]. The parameters resulting from these equations are highly significant because when the depth of the drawn part exceeds its diameter, the process will be considered a deep drawing process.…”

Section: Micro-deep Drawing Die Designmentioning

confidence: 99%

“…4 is 0.266 mm. To find the drawing force, equation ( 5) is used [28], which is found to be 140 N/mm2. The drawing force helps to estimate how many loads need to be completed in the drawing process.…”

Section: Micro-deep Drawing Die Designmentioning

confidence: 99%

“…F, L, t, S, D, d, and C are the drawing force, the product perimeter, the blank thickness, the yield strength of metal, the blank diameter, the product diameter, and the clearance between punch and die, respectively. The strain factor is determined by using equation ( 6) [28],…”

Section: Micro-deep Drawing Die Designmentioning

confidence: 99%

See 2 more Smart Citations

Lubricating materials as a novel approach to reduce defects of micro-deep drawing forming process

Khalil,

Shaker,

Yaseen

et al. 2024

J Appl Eng Science

View full text Add to dashboard Cite

The deep drawing forming process, classified under sheet metal working, is a promising and essential metal forming process that has attracted much interest due to its wide application in micro-production. The process parameters, such as the cross-head speed of the machine, have a significant influence on the quality of the product. The impact of two essential parameters was investigated to minimize or eliminate the product's production defects, such as thinning, tearing, and scratching. The first one was the impact of using two types of lubricating oil (grease and wax), and the products were compared with the dry condition (without using a lubricating oil). The second is the impact of changing the cross-head speed of the machine from 5 to 15 mm/min. This work aims to determine the optimum operating condition that prevents any defect in the product. The results showed that using lubricating oil resulted in better product shape, and the wax is better than grease in eliminating product defects. In addition, the results showed that the lower machine speed is preferred for eliminating production defects, where the final product has no obvious thinning, tearing, or scratching. The final product shape was evaluated visually because eye observation is the only way to judge the product shape.

show abstract

Section: Micro-deep Drawing Die Designmentioning

confidence: 99%

Section: Micro-deep Drawing Die Designmentioning

confidence: 99%