Effect of regeneration method and ash deposition on diesel particulate filter performance: a review

Luo, Jianbin; Tie, Yuanhao; Tang, Lifei; Li, Yuan; Xu, Hongxiang; Liu, Zhonghang; Li, Mingsen; Zhang, Haiguo; Zhang, Zhiqing

doi:10.1007/s11356-023-25880-2

Cited by 18 publications

(2 citation statements)

References 225 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Additionally, related research focuses on the development of new regenerative filter materials [26][27][28]. Graphene and its derivatives have become a hot topic in materials synthesis due to their specific characteristics [26,27].…”

Section: Introductionmentioning

confidence: 99%

Experimental Study of the Factors Influencing the Regeneration Performance of Reduced Graphite Oxide Filter Materials under Water Cleaning

Yang

Zhang

et al. 2023

Materials

View full text Add to dashboard Cite

With the normalization of epidemic prevention and control, air filters are being used and replaced more frequently. How to efficiently utilize air filter materials and determining whether they have regenerative properties have become current research hotspots. This paper discusses the regeneration performance of reduced graphite oxide filter materials, which were studied in depth using water cleaning and the relevant parameters, including the cleaning times. The results showed that water cleaning was most effective using a 20 L/(s·m2) water flow velocity with a 17 s cleaning time. The filtration efficiency decreased as the number of cleanings increased. Compared to the blank group, the filter material’s PM10 filtration efficiency decreased by 0.8%, 19.4%, 26.5%, and 32.4% after the first to fourth cleanings, respectively. The filter material’s PM2.5 filtration efficiency increased by 12.5% after the first cleaning, and decreased by 12.9%, 17.6%, and 30.2% after the second to fourth cleanings, respectively. The filter material’s PM1.0 filtration efficiency increased by 22.7% after the first cleaning, and decreased by 8.1%, 13.8%, and 24.5% after the second to fourth cleanings, respectively. Water cleaning mainly affected the filtration efficiency of particulates sized 0.3–2.5 μm. Reduced graphite oxide air filter materials could be water washed twice and maintain cleanliness equal to 90% of the original filter material. Water washing more than twice could not achieve the standard cleanliness equal to 85% of the original filter material. These data provide useful reference values for the evaluation of the filter materials’ regeneration performance.

show abstract

Section: Introductionmentioning

confidence: 99%

Experimental Study of the Factors Influencing the Regeneration Performance of Reduced Graphite Oxide Filter Materials under Water Cleaning

Yang

Zhang

et al. 2023

Materials

View full text Add to dashboard Cite

show abstract

“…With the improvement of people’s quality of life and the development of urbanization, the demand for transportation is increasing. A large number of motor vehicles leads to many problems (Xin and Su, 2021) such as traffic jams (Li et al , 2020), environmental pollution (Cai and Zhao, 2022; Luo et al , 2023; Zhang et al , 2023) and energy waste (Smith et al , 2013). At present, governments and related agencies worldwide recognize the harm caused by the increase in motor vehicles.…”

Section: Introductionmentioning

confidence: 99%

Aerodynamic optimization of mixed platoon Ahmed body vehicles based on response surface method

Luo,

Tie,

et al. 2023

HFF

Self Cite

View full text Add to dashboard Cite

Purpose The purpose of this paper is to investigate the optimal average drag coefficient of the Ahmed body for mixed platoon driving under crosswind and no crosswind conditions using the response surface optimization method. This study has extraordinary implications for the planning of future intelligent transportation. Design/methodology/approach First, the single vehicle and vehicle platoon models are validated. Second, the configuration with the lowest average drag coefficient under the two conditions is obtained by response surface optimization. At the same time, the aerodynamic characteristics of the mixed platoon driving under different conditions are also analyzed. Findings The configuration with the lowest average drag coefficient under no crosswind conditions is 0.3 L for longitudinal spacing and 0.8 W for lateral spacing, with an average drag coefficient of 0.1931. The configuration with the lowest average drag coefficient under crosswind conditions is 10° for yaw angle, 0.25 L for longitudinal spacing, and 0.8 W for lateral spacing, with an average drag coefficient of 0.2251. Compared to the single vehicle, the average drag coefficients for the two conditions are reduced by 25.1% and 41.3%, respectively. Originality/value This paper investigates the lowest average drag coefficient for mixed platoon driving under no crosswind and crosswind conditions using a response surface optimization method. The computational fluid dynamics (CFD) results of single vehicle and vehicle platoon are compared and verified with the experimental results to ensure the reliability of this study. The research results provide theoretical reference and guidance for the planning of intelligent transportation.

show abstract

Effect analysis on passive and active regeneration performance of catalytic diesel particulate filters at the equilibrium point in the presence of ash layer

Zhong,

Wang,

Chen

et al. 2024

Can J Chem Eng

View full text Add to dashboard Cite

Catalytic diesel particulate filters (CDPF) form the main post‐processing devices for the diesel engines. Particulates trapped by CDPF can be oxidized by nitrogen dioxide (NO2) and oxygen (O2). The CDPF passive and active regeneration model on platinum‐based catalyst in the presence of ash layer, including the mass, momentum, and enthalpy balances of the gas and the solid phase, the gas diffusion, and the kinetic of the soot oxidation reaction is performed and validated by the bench test. The effects of different temperatures on CDPF passive and active regeneration at the equilibrium point are analyzed. Further, the effective analysis of ash loading and ash layer distribution on the equilibrium state is conducted. The research on CDPF passive and active regeneration at the equilibrium point in the presence of ash layer provides a theoretical basis for CDPF application.

show abstract

Effect of regeneration method and ash deposition on diesel particulate filter performance: a review

Cited by 18 publications

References 225 publications

Experimental Study of the Factors Influencing the Regeneration Performance of Reduced Graphite Oxide Filter Materials under Water Cleaning

Experimental Study of the Factors Influencing the Regeneration Performance of Reduced Graphite Oxide Filter Materials under Water Cleaning

Aerodynamic optimization of mixed platoon Ahmed body vehicles based on response surface method

Effect analysis on passive and active regeneration performance of catalytic diesel particulate filters at the equilibrium point in the presence of ash layer

Contact Info

Product

Resources

About