Effect of thermo-hydrodynamic instability on structure and characteristics of filtration combustion wave of solid fuel

Rabinovich, O. S.; Malinouski, Andrei I.; Кислов, В. М.; Salgansky, E. A.

doi:10.1080/13647830.2016.1190034

Cited by 20 publications

(1 citation statement)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Bed temperature inhomogeneity has been investigated relative to its role in smouldering reaction dynamics. Namely, its influence on injected air flow rates ( Levin and Lutsenko, 2006 , 2008 ), non-uniform air flux ( Rashwan et al, 2021c ), pressure changes within smouldering reactors ( Zanoni et al, 2021 ) and reaction front instability ( Chen et al., 2018 ; Rabinovich et al, 2016 ). Relatedly, the results of this work provide the first investigation into how bed temperature inhomogeneities derived during the smouldering phase can have ramifications for the cooling phase.…”

Section: Resultsmentioning

confidence: 99%

Understanding, controlling and optimising the cooling of waste thermal treatment beds including STARx Hottpads

et al. 2022

View full text Add to dashboard Cite

STARx (Self-sustaining Treatment for Active Remediation ex situ) is a thermal treatment strategy for contaminated soils and organic wastes. Key to this technology is that organics are embedded in porous matrix beds (e.g. sand). STARx induces a self-sustaining smouldering combustion front that traverses the bed, burning away the embedded contaminants/wastes. The time and cost effectiveness of this technology is largely dictated by the time required for cooling of the hot, clean, porous matrix bed that remains after treatment. This study is the first to explore the cooling of these beds. A suite of novel simulations investigated the influence of key parameters on bed-cooling time. The results reveal that cooling time decreased nearly linearly with decreases of volume-averaged bed temperature and bed bulk density. Increased injection air fluxes led to the non-linear decrease of cooling time. Also, cooling time was negatively impacted by bed temperature inhomogeneity, which influenced preferential air flow through cooler regions of the bed, bypassing hotter regions. From these results, using lower bulk density bed materials, increased air fluxes and enhancing wall insulation to improve bed temperature homogeneity were identified as system optimisations to reduce cooling times. While the aim of this research is to improve the STARx cooling process, the results are also highly applicable to many similar engineering systems that involve hot porous bed cooling.

show abstract