Effects of Process Parameters onMachining Time in Wire Electrical Discharge Machining of 9CrSi Steel

In this paper, Study on Material expulsion rate and Surface Roughness of H13 die tool using Wire cut EDM process is focused. H 13 chromium hot work steel is far and wide used in hot and freezing work tooling purpose. Due to its excellent amalgamation of high robustness and fatigue resistance H13 is used more than any supplementary tool steel in tooling applications. The H-13 hot die-hard substance dimension 103.70 mm x 13.95 mm has been utilized as a work section substance in favor of the current research, wire electrode of brass having standard diameter 0.25 mm is used as electrode. Four Parameters (TON, TOFF, WF and voltage) are chose to consider its impact on cutting rate and surface harshness. Taguchi Plan of technique is used in the experimentation & analyze by Minitab 15 programming. Observations brings voltage is the most noteworthy boundaries on SR where Ton and Toff are less critical and also observed that MRR amplify with enhance in Ton and WF and diminish on escalating of Vg and Toff.

show abstract

Effects of Process Parameters onMachining Time in Wire Electrical Discharge Machining of 9CrSi Steel

Cited by 3 publications

References 0 publications

Multi-objective Optimization of Process Parameters During Electrical Discharge Machining of Hardened 90CrSi Steel by Applying Taguchi Technique with Grey Relational Analysis

Multi-objective Optimization of Process Parameters During Electrical Discharge Machining of Hardened 90CrSi Steel by Applying Taguchi Technique with Grey Relational Analysis

Experimental investigation on wire electrical discharge machining parameters for aluminium 6082 T6 alloy using Taguchi design

Optimization of process parameters for Surface Roughness and Material Removal Rate of H13 die tool steel for wire EDM using Taguchi Technique

Contact Info

Product

Resources

About