Evaluation of two different alternatives of energy recovery from municipal solid waste in Brazil

Abstract

Brazil has a large population with a high waste generation. The municipal solid waste (MSW) generated is deposited mainly in landfills. However, a considerable fraction of the waste is still improperly disposed of in dumpsters. In order to overcome this inadequate deposition, it is necessary to seek alternative routes. Between these alternatives, it is possible to quote gasification and incineration. The objective of this study is to compare, from an energetic and economic point of view, these technologies, aiming at their possible implementation in Brazilian cities. A total of two configurations were evaluated: (i) waste incineration with energy recovery and electricity production in a steam cycle; and (ii) waste gasification, where the syngas produced is used as fuel in a boiler of a steam cycle for electricity production. Simulations were performed assuming the same amount of available waste for both configurations, with a composition corresponding to the MSW from Santo André, Brazil. The thermal efficiencies of the gasification and incineration configurations were 19.3% and 25.1%, respectively. The difference in the efficiencies was caused by the irreversibilities associated with the gasification process, and the additional electricity consumption in the waste treatment step. The economic analysis presented a cost of electrical energy produced of 0.113 (US$ kWh) and 0.139 (US$ kWh) for the incineration and gasification plants respectively.

Open Burning of Household Solid Waste and Child Respiratory Health: Evidence From Indonesia

“…When the latter is not separated from the former, it may also get burnt and emanate harmful pollution that can hurt the people around. Many costeffective technologies that can be used to recover energy from waste and reduce pollution are available (Jimenez et al, 2017). However, developing countries like Indonesia may not have the financial capacity to afford those technologies (Bogner et al, 2007).…”

Caracterización Física-Química-Energética De Pellets De Hojarasca Residual Como Biocombustible Renovable

“…El aumento de la producción de residuos se asocia con el crecimiento de la población (Medina Jimenez et al, 2017). La producción de desechos en Medellín es de aproximadamente 1800 ton/día, con una tasa de generación per cápita de alrededor de 0.45 kg/habitante/día.…”

Energy, Exergy, Economic, Environmental (4e) Analysis of Hybrid Systems for Electricity Generation From Municipal Solid Waste and Natural Gas

“…According to [12], the steam turbine isentropic efficiency range is 80-90%. Other sources [56], [25] assume 85% and 90%. Consulting Thermoflex ® library for an additional reference, it is found that the default ST "dry step efficiency" is 85%, however, it varies with the stage (ranging between 87.5-92.2% in the investigated cases) and being higher for LP than for HP.…”

“…The pump isentropic efficiency ranges between 70-75% [56], [58]. Consulting Thermoflex ® library for an additional reference, it is found that the default isentropic efficiency of an integral motor pump is 75%.…”

“…The non-combusted material (1.7% in mass) is considered as majorly scrap metal donated to recycling units. Based on gate fee values reported for developing countries in [47], [56], [22], [79]; two types of final disposal costs are assumed as reference for Brazilian landfills: US$ 15/ton for non-hazardous and US$ 20/ton for hazardous material (flying ash).…”