Experimental investigation on a solar parabolic collector using water-based multi-walled carbon-nanotube with low volume concentrations

Abstract

A limited experimental work was on multi-walled carbon nanotube (MWCNT)—water nanofluid with surfactant in the solar parabolic collector at low volume concentrations. At high-volume concentrated nanofluid, the pressure drop was more due to an increase in the viscosity of the working fluid and an increase in the nanoparticle cost; hence it is not economical. This report attempted to use Sodium Dodecyl Benzene Sulfonate (SDBS) surfactant in the low-volume concentrated MWCNT-water nanofluid to establish effective heat transfer in solar parabolic collector applications. The stable MWCNT-water nanofluid was prepared at 0.0158, 0.0238, and 0.0317 volume concentrations. The experiments were conducted from 10:00 to 16:00 at 6, 6.5 and 7 L/min flow rates concerning ASHRAE Standards. At the 7 L/min flow rate of the working fluid, having a minimum temperature difference between the working fluid and absorber tube leads to better heat transfer. The increased volume concentration of MWCNT in the water enhances the surface area interaction between water and MWCNT nanoparticles. This results in maximum solar parabolic collector efficiency at 0.0317 vol% with a 7 L/min flow rate and 10–11% higher than the distilled water.

Numerical simulation for impact of implement of reflector and turbulator within the solar system in existence of nanomaterial

“…In another study, Adnan et al 13 analyzed the impact of non-linear radiative heat flux on nanofluid flow through a squeezing duct. Talugeri et al 14 conducted an experimental work on a concentrated solar unit. The experiments were carried out between 10:00 and 16:00, with various flow rates.…”