Experimental study on the effects of integrating phase change material with a solar updraft tower

Abstract

The solar updraft tower power plant presents a promising renewable energy solution but faces limitations in thermal efficiency and energy production during nonsunny hours. This study addresses a critical gap in the literature by investigating the integration of latent heat storage systems utilizing paraffin wax as phase change materials (PCMs) to enhance solar updraft tower (SUT) performance. Two identical small‐scale SUTs were constructed, both using the same tank configuration; however, the PCM device was filled with paraffin wax as a PCM, while the non‐PCM device contained only atmospheric air. Three scenarios were explored, featuring varying PCM tank heights of 2, 4, and 6 cm (the full capacity of the PCM tank). Results indicated that, from 3 p.m. until sunset, the PCM‐integrated SUT in Case 3 (with 6 cm of PCM) achieved the best performance, with an average absorber temperature rise of 25°C, compared with 12°C for the non‐PCM device. During the same period, the average air velocity at the tower neck, where a wind turbine could be installed, was 1.21 m/s for the PCM device, versus 0.82 m/s for the non‐PCM device. Notably, the nocturnal operating time extended significantly with PCM use, rising from 90 min for the 2 cm case to 125 min for the 6 cm case. In contrast, the non‐PCM device exhibited no operational time after sunset. This research not only demonstrates the effectiveness of PCM in improving the thermal performance and operational longevity of SUTs but also introduces a novel tank configuration that allows for flexible PCM integration, representing a significant advancement in the development of more efficient SUT systems.