Experimental study on the oxidation kinetics of coal in typical coal mining areas of the Southern Junggar coalfield, Xinjiang, China

Abstract

Coal spontaneous combustion (CSC) is a disaster associated with coal mining that leads to loss of coal resources and environmental and human health issues. To investigate kinetic characteristics for oxidation of coal, three coal samples were collected from different coal mining areas in the Southern Junggar coalfield. Subsequently, the collected coal samples were ground into different particle sizes and tested using microscopic and macroscopic methods, including thermal gravimetric analysis, Fourier transform infrared spectroscopy, X-ray diffraction, and temperature-programmed oxidation. The results obtained are as follows: the sharpest absorption peak (002) indicates that graphitization is high. Furthermore, the results show that the SKS coal sample is prone to spontaneous combustion; the greater the aromatic hydrocarbon content is, the more difficult it is for CSC to occur, while the opposite is true for oxygen-containing functional groups. The SKS data confirmed this conclusion; the rate for generation of CO and CO2 controlled the possibility of SKS oxidation at 110 °C and provided an indication of the temperature. During the dehydration stage, the WD sample had the lowest activation energy, indicating that it was most susceptible to spontaneous combustion. During the combustion stage, the lowest activation energy was found for the SKS sample with particle sizes < 0.075 mm, indicating that particle size was one of the factors affecting spontaneous combustion. The activation energy for dehydration was significantly lower than that for combustion, which showed that the coal oxygen reaction was more likely to occur in the dehydration stage. Based on DSC curves, the SKS sample had the largest exothermicity, indicating that it would ignite more readily.

Research on Hydraulic Fracturing Pressure Relief and Improvement Permeability Technology of the Soft Coal Seam Roof

“…The geological structure of coal measures in China is generally complex, and the mining method is mainly underground. − The proportion of the soft coal seam is as high as 82%. This kind of coal seam has the characteristics of soft and broken coal mass, low permeability, and a large gas content. − In addition, with the increase of the depth of the coal seam, in situ stress, gas content, and gas pressure gradually increase . Under the influence of high ground stress, there are often phenomena such as sticking, jetting, and hole collapse in the construction of gas predrainage boreholes.…”

Characteristics of coal oxidation and spontaneous combustion in Baishihu Mine, Xinjiang, China

“…Based on the construction of a molecular structure model to study the characteristics of coal, Lin et al (2019) analyzed the molecular structure differences between tectonic coal and primary coal in the Pingdingshan coalfield. Zeng and Shen (2022) used thermogravimetric analysis (TGA), Fourier infrared spectroscopy (FTIR), X-ray diffraction (XRD), and temperatureprogrammed oxidation to characterize the spontaneous combustion characteristics of coal samples. Ghosh et al (2020) used Raman spectroscopy, FTIR, and X-ray photoelectron spectroscopy to study the microstructural framework of coal in Langanji and Jaria basins and the Himalayas.…”