Finishing technique effect on strength of zirconia‐reinforced lithium silicate ceramic

Abstract

The aim of this study was to evaluate the effect of two finishing techniques, glazing or polishing, in comparison with the as‐cut condition, on the biaxial‐flexural‐strength (BFS) of a zirconia‐reinforced lithium silicate ceramic (ZLS). Cylinders were milled from CAD/CAM blocks and sliced to obtain disc‐shaped specimens (ISO6872:2015). Polished and glazed specimens were processed following the manufacturer's instructions. Thirty‐three specimens were obtained for each condition and microstructural and BFS/fractographic characterizations were performed. BFS and roughness data were analyzed using Weibull statistics and ANOVA one‐way with Tukey post‐hoc test, respectively. While a rougher surface was observed for as‐cut specimens, smoother surfaces were observed for polished and glazed ZLS at microscopical evaluation and confirmed through surface‐roughness evaluation. X‐ray spectra depicted a glass phase for all groups and characteristic metasilicate, lithium disilicate, and lithium phosphate peaks for the as‐cut and polished specimens. Glazed specimens showed higher characteristic strength than polished and as‐cut specimens, which did not differ significantly. While higher Weibull‐modulus was observed for the polished than for the as‐cut specimens, no statistically significant differences were noted between glazed and polished, and between glazed and as‐cut specimens. ZLS presents higher strength when glazed, and polishing increases the structural reliability of the material relative to the as‐cut condition. Both finishing techniques reduced surface roughness similarly.