Full-Time, Eye-Safe Cloud and Aerosol Lidar Observation at Atmospheric Radiation Measurement Program Sites: Instruments and Data Processing

Campbell, James; Hlavka, Dennis L.; Welton, Ellsworth J.; Flynn, Connor; Turner, David D.; Spinhirne, James D.; Scott, V. Stanley; Hwang, In Heon

doi:10.1175/1520-0426(2002)019<0431:ftesca>2.0.co;2

Cited by 366 publications

(315 citation statements)

References 10 publications

Supporting

Mentioning

309

Contrasting

Unclassified

Order By: Relevance

“…Final-corrected P , P || and P ⊥ are obtained using the procedure described in Campbell et al (2002) and Welton and Campbell (2002). The linear volume depolarization ratio, δ V , in a classical sense (Sassen, 1991), can be defined as…”

Section: Polarized Micro-pulse Lidar (P-mpl) Systemmentioning

confidence: 99%

Separation of the optical and mass features of particle components in different aerosol mixtures by using POLIPHON retrievals in synergy with continuous polarized Micro-Pulse Lidar (P-MPL) measurements

et al. 2018

View full text Add to dashboard Cite

Abstract. The application of the POLIPHON (POlarizationLIdar PHOtometer Networking) method is presented for the first time in synergy with continuous 24/7 polarized MicroPulse Lidar (P-MPL) measurements to derive the vertical separation of two or three particle components in different aerosol mixtures, and the retrieval of their particular optical properties. The procedure of extinction-to-mass conversion, together with an analysis of the mass extinction efficiency (MEE) parameter, is described, and the relative mass contribution of each aerosol component is also derived in a further step. The general POLIPHON algorithm is based on the specific particle linear depolarization ratio given for different types of aerosols and can be run in either 1-step (POL-1) or 2 steps (POL-2) versions with dependence on either the 2-or 3-component separation. In order to illustrate this procedure, aerosol mixing cases observed over Barcelona (NE Spain) are selected: a dust event on 5 July 2016, smoke plumes detected on 23 May 2016 and a pollination episode observed on 23 March 2016. In particular, the 3-component separation is just applied for the dust case: a combined POL-1 with POL-2 procedure (POL-1/2) is used, and additionally the fine-dust contribution to the total fine mode (fine dust plus non-dust aerosols) is estimated. The high dust impact before 12:00 UTC yields a mean mass loading of 0.6 ± 0.1 g m −2 due to the prevalence of Saharan coarse-dust particles. After that time, the mean mass loading is reduced by two-thirds, showing a rather weak dust incidence. In the smoke case, the arrival of fine biomass-burning particles is detected at altitudes as high as 7 km. The smoke particles, probably mixed with less depolarizing non-smoke aerosols, are observed in air masses, having their origin from either North American fires or the Arctic area, as reported by HYSPLIT backtrajectory analysis. The particle linear depolarization ratio for smoke shows values in the 0.10-0.15 range and even higher at given times, and the daily mean smoke mass loading is 0.017 ± 0.008 g m −2 , around 3 % of that found for the dust event. Pollen particles are detected up to 1.5 km in height from 10:00 UTC during an intense pollination event with a particle linear depolarization ratio ranging between 0.10 and 0.15. The maximal mass loading of Platanus pollen particles is 0.011 ± 0.003 g m −2 , representing around 2 % of the dust loading during the higher dust incidence. Regarding the MEE derived for each aerosol component, their values are in agreement with others referenced in the literature for the specific aerosol types examined in this work: 0.5 ± 0.1 and 1.7 ± 0.2 m 2 g −1 are found for coarse and fine dust particles, 4.5 ± 1.4 m 2 g −1 is derived for smoke and 2.4 ± 0.5 m 2 g −1 for non-smoke aerosols with Arctic origin, and a MEE of 2.4 ± 0.8 m 2 g −1 is obtained for pollen particles, though it can reach higher or lower values depending on predomiPublished by Copernicus Publications on behalf of the European Geosciences Union. 4776 C. Córdoba...

show abstract

Section: Polarized Micro-pulse Lidar (P-mpl) Systemmentioning

confidence: 99%

Separation of the optical and mass features of particle components in different aerosol mixtures by using POLIPHON retrievals in synergy with continuous polarized Micro-Pulse Lidar (P-MPL) measurements

et al. 2018

View full text Add to dashboard Cite

show abstract

“…At the same period with our study, the aerosol vertical distribution was determined by using NASA MicroPulse Lidar Network (http://mplnet.gsfc.nasa.gov/; Welton et al, 2001;Campbell et al, 2002), that found at DAK, with 532 nm extinction coefficient profiles solved. They revealed a decreasing mixed layer height and stable synoptic conditions (i.e., high pressure and weak wind speed).…”

Section: Pm 25 Concentrationsmentioning

confidence: 99%

Investigation of Biomass Burning Chemical Components over Northern Southeast Asia during 7-SEAS/BASELInE 2014 Campaign

Khamkaew

Chantara

Janta

et al. 2016

Aerosol Air Qual. Res.

View full text Add to dashboard Cite

This study investigates the chemical components of biomass burning (BB) aerosols obtained from Doi Ang Khang (DAK; near BB source) and Chiang Mai University (CMU; an urban location) over northern Southeast Asia in dry season (March to mid-April) 2014. PM 2.5 (particulate matter with an aerodynamic diameter less than or equal to 2.5 µm) samples were collected over a 24-h sampling period as a part of the Seven South East Asian Studies ) and CMU (90.7-93.1 µg m -3 ) were not significantly different (p > 0.05) and well correlated (r = 0.8), and likely originated from similar source origins. The number of fire hotspots was particularly high during 20-21 March (greater than 200) and, consequently, peaks of PM 2.5 were recorded at both sites. The most abundant elements at both sampling sites were K (49-50% of total elements), Al (26-31%), Mg (16%) and Zn (4-7%), whereas SO 4 2-(30-38% of total ions), NO 3 -(13-20%), Na + (16-20%) and NH 4 + (14-15%) were the most abundant ions. Concentrations of levoglucosan and K + (BB tracers) were well correlated (r = 0.5 for CMU and 0.7 for DAK) confirming that the PM 2.5 detected in these areas were mainly influenced by BB activity. Principal component analysis (PCA) revealed that BB, road traffic, agricultural activity and soil re-suspension were plausible sources of PM 2.5 over the study locations. Apart from local sources, the influence of long-range transport was also investigated by way of three-day backward trajectory analysis.

show abstract

“…The instrument is joint-operated by the Taiwan EPA and NCU. The standard instrument design, basic processing algorithm, and the NRB parameter are described by Campbell et al [2002]. Our system supports long-term measurements with 1.0 min temporal and 0.075 km vertical resolutions.…”

Section: Lidarmentioning

confidence: 99%

Impact of Asian dust and continental pollutants on cloud chemistry observed in northern Taiwan during the experimental period of ABC/EAREX 2005

Wang¹,

Lin²,

Ou-Yang³

et al. 2010

J. Geophys. Res.

Self Cite

View full text Add to dashboard Cite

Observations of particulate matter (PM), vertical cloud and aerosol structure and cloud water chemistry in northern Taiwan were conducted during the ABC/EAREX 2005 period. Five Asian continental outflow regimes reaching Taiwan were identified. One was coupled with a dust storm observed not only at Gosan, Korea, but also over Taiwan, suggesting the scope of its regional impact. The arrival of the dust event was determined by lidar, cloud water, and surface PM measurements. When continental outflow events correspond to the presence of significant dust concentrations, air quality can be drastically worsened due to high levels of PM. PM10 (PM with aerodynamic diameters < 10 μm), pH, conductivity, and ion concentrations of cloud water increased drastically near the dissipating stage of the frontal passage/cloud event for the dust case. Cloud water may have become acidified by pollution from industrial and urban regions along the coast of eastern China. Nevertheless, abundant Ca2+ contributed to the neutralization of acidic cloud water during the dust stage. The much higher aerosol and chemical loading injected into these clouds caused an enrichment effect in the cloud water, which can double the cloud loading of total ions, when Ca2+ increases by approximately 7 times.

show abstract

Full-Time, Eye-Safe Cloud and Aerosol Lidar Observation at Atmospheric Radiation Measurement Program Sites: Instruments and Data Processing

Cited by 366 publications

References 10 publications

Separation of the optical and mass features of particle components in different aerosol mixtures by using POLIPHON retrievals in synergy with continuous polarized Micro-Pulse Lidar (P-MPL) measurements

Separation of the optical and mass features of particle components in different aerosol mixtures by using POLIPHON retrievals in synergy with continuous polarized Micro-Pulse Lidar (P-MPL) measurements

Investigation of Biomass Burning Chemical Components over Northern Southeast Asia during 7-SEAS/BASELInE 2014 Campaign

Impact of Asian dust and continental pollutants on cloud chemistry observed in northern Taiwan during the experimental period of ABC/EAREX 2005

Contact Info

Product

Resources

About