Fuzzy logic-based water heating control methodology for the efficiency enhancement of hybrid PV–PEM electrolyser systems

Tabanjat, Abdulkader; Becherif, Mohamed; Emziane, Mahieddine; Hissel, Daniel; Ramadan, Haïtham Saad Mohamed; Mahmah, Bouziane

doi:10.1016/j.ijhydene.2014.11.135

Cited by 46 publications

(15 citation statements)

References 36 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A fuzzy logic based water heating control was proposed by Tabanjat et al [102]. The goal is to control the water supply of a PEM electrolyzer to a pre determined temperature via a controlled water flow circuit in order to enhance PEM efficiency.…”

Section: Control Strategies For Pemfcmentioning

confidence: 99%

A review of fault tolerant control strategies applied to proton exchange membrane fuel cell systems

Dijoux

Steiner

Benne

et al. 2017

Journal of Power Sources

View full text Add to dashboard Cite

International audienceFuel cells are powerful systems for power generation. They have a good efficiency and do not generate greenhouse gases. This technology involves a lot of scientific fields, which leads to the appearance of strongly inter dependent parameters. This makes the system particularly hard to control and increases fault's occurrence frequency. These two issues call for the necessity to maintain the system performance at the expected level, even in faulty operating conditions. It is called " fault tolerant control " (FTC). The present paper aims to give the state of the art of FTC applied to the proton exchange membrane fuel cell (PEMFC). The FTC approach is composed of two parts. First, a diagnosis part allows the identification and the isolation of a fault; it requires a good a priori knowledge of all the possible faults. Then, a control part allows an optimal control strategy to find the best operating point to recover/ mitigate the fault; it re quires the knowledge of the degradation phenomena and their mitigation strategies

show abstract

Section: Control Strategies For Pemfcmentioning

confidence: 99%

A review of fault tolerant control strategies applied to proton exchange membrane fuel cell systems

Dijoux

Steiner

Benne

et al. 2017

Journal of Power Sources

View full text Add to dashboard Cite

show abstract

“…On the other side, compared to the AEL, the PEM is relatively a new technology where the first commercial PEM electrolyzer was available in the market since in 1978. This technology is based on the use of a solid polymer membranes, where the Oxygen and the hydrogen are produced at the anode and cathode sides respectively as explained in the reaction presented in equations (1)(2)(3). The most commonly used membrane material is Nafion [8,10,11].…”

Section: Pem Electrolyzermentioning

confidence: 99%

“…The storage systems are one among such options to improved the quality of electric power based on renewable energy sources, where these systems ensure the storage of the excess energy during overproduction or under consumption periods [2]. For this purpose, several indirect electrical energy storage systems have been used such as compressed air energy storage system (CAESS), pumped hydro energy storage system (PHESS), flywheel energy storage system (FESS) , battery energy storage system (BESS), hydrogen and Methane or Synthetic Natural Gas (SNG) [3]. In this work the storage of energy via the production of Hydrogen ( 2 H ) and Methane ( 4 CH ) is investigated, these systems are known as the Power to Gas (PtG) storage systems, they are actually attracting more attention of energy actors, industries and researchers, where these systems are the keystone in hybrid renewable energy systems (HRES).…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Techno Economic Assessment of Hybrid Renewable Energy Systems Based on Power to Hydrogen and Methane Gas Concepts

Boubenia¹,

Hafaifa²,

Kouzou³

et al. 2018

Preprint

View full text Add to dashboard Cite

This paper deals with the techno-economic study of the hybrid renewable energy system based on energy storage aspect under the form of hydrogen and methane. Indeed, with the intermittency of the renewable energy sources such as photovoltaic and wind energy, several problems of produced energy injection to the power system network can be encountered due to the shortage or the excess of these sources. This situation appeals the use of systems that ensure the stability of network based on the storage of energy surplus into gas using electrolyzer systems, which will be used afterward to cover the eventual shortage. In the present paper, the study of performance of each pathway of methane and hydrogen storage has been performed by the treatment of multiple scenarios via different architecture case studies in an Algerian location. Whereas, the energy produced by the photovoltaic system, the wind energy and the gas micro turbine sources are considered similar in each case. The modeling and simulation of the studied system operation under optimization criteria has been performed in this work, where the main aim is to define the appropriate configuration taking into account the different with low costs of investment, maintenance operation and immediate reactivity with a big storage capacity.

show abstract

“…Hence induction electromagnetic heating mode is also available for heating furnace. A. Tabanjat, M.Becherif, M.Emziane, D.Hissel, H.S.Ramadan and B.Mahmah utilized fuzzy logic theory to control water heating system to improve the heating efficiency of hybrid PV-PEM electrolyser systems [3]. Fuzzy control theory may be utilized to control water heating management system.…”

Section: Introductionmentioning

confidence: 99%

Spatial Cycle Heating and Its PLC Control for Furnace

Zhou¹,

Cui²,

Zhao³

et al. 2017

dtetr

View full text Add to dashboard Cite

Abstract. Aim at lower heating efficiency problem of furnace, the spatial cycle heating principle was brought forward and the testifying device was designed and fabricated. After the traditional heating principle was abstracted, modeled, narrated and analyzed, the obvious defect of lower heating efficiency was pointed out and analyzed in theory. The spatial cycle heating model was put forward to improve heating efficiency. And then different expressions aim at given models were deduced and compared. In theory, it was gained that the spatial cycle heating mode had a higher heating efficiency than traditional heating mode. Then a testifying experiment device was designed and constructed in terms of spatial cycle heating principle. PLC controller was employed to realize the closed-loop feedback control. Water temperature was the output of PLC control system. Temperature sensor was used to sample output and then to feedback to PLC controller. Heating resistors were considered as actuators. Furthermore, touch screen was also employed to control PLC controller and to dynamically display the water temperature. Experiment and its analytic results well demonstrated that the spatial cycle heating model could further improve the heating efficiency. Namely, spatial cycle heating principle is correct and effective and available for improving heating efficiency in furnace. It is very suitable for massive heating case such as winter heating.

show abstract

Fuzzy logic-based water heating control methodology for the efficiency enhancement of hybrid PV–PEM electrolyser systems

Cited by 46 publications

References 36 publications

A review of fault tolerant control strategies applied to proton exchange membrane fuel cell systems

A review of fault tolerant control strategies applied to proton exchange membrane fuel cell systems

Techno Economic Assessment of Hybrid Renewable Energy Systems Based on Power to Hydrogen and Methane Gas Concepts

Spatial Cycle Heating and Its PLC Control for Furnace

Contact Info

Product

Resources

About