High efficiency DC-DC converter with twin-bus for dimmable LED lighting

Abstract

A novel twin-bus converter using n + 1 active switches is proposed for the n-string LEDs to be dimmable from true zero to the rated current level. With the proposed twin-bus structure, the n-switches that perform the current-loop regulation can operate at very high frequency because of significantly reduced voltage stresses, while achieving high efficiency over a wide load range. With operating frequency exceeding 1 MHz in the test case, the proposed LED driver demonstrates ultra compact size inductor and fast slew rates of the LED current. The dimming controlled switch, however, can operate at a low frequency to ensure high-efficiency operation without light flicker. The detailed power stage operating principle and control scheme of the individual string current for the presented converter are described. Experimental results of a 3-string 50-W LED driver hardware prototype show that the independent string current can be regulated from zero to the desired 350 mA for dimming control. A peak efficiency of 98.3% was achieved with 1.08 MHz switching frequency.Index Terms--High efficiency, DC-DC converter, light emitting diode, Dimmable LED drive, offline LED lighting 978-1-4244-5287-3/10/$26.00 ©2010 IEEE

DC microgrids and distribution systems: An overview

“…Electronic based office and home appliances, such as computers, laptops, tablets, phones, printers, TVs [2], microwave ovens [3] and lighting, consume electricity in DC form [4][5][6][7]. Newer more-efficient lighting technologies such as compact fluorescent fixtures and solid-state lighting involve a DC stage and hence it is more efficient to utilize them in a DC distribution system [8,9]. DC power is used in Variable Speed Drives (VSD) for pumps, Heating, Ventilation and Air Conditioning (HVAC) systems, fans, elevators, mills and traction systems.…”

Matching LED and Driver Life Spans: A Review of Different Techniques

“…The multiple-stage approach gives more speed and flexibility to control the output luminosity [38], [44]. This is necessary when bilevel [14] or even pulsewidth modulation (PWM) techniques are to be employed for the LED light modulation [41], [44]- [46]. A switching converter could be employed to control each branch of LEDs.…”

“…A switching converter could be employed to control each branch of LEDs. A concept known as twin-bus takes advantage of the knee voltage of the LED [38], [46] to increase the efficiency of conversion by reducing the voltage stress on the semiconductors, thus enabling a full-dimming …”

Get the LED Out: Experimental Validation of a Capacitor-Free Single-Inductor, Multiple-Output LED Driver Topology

“…For modern applications, the reduction of external components in stand-alone ac-dc LED lamps is favored [7]- [10]. For higher individuality, distributed intelligent dc-dc LED driver modules are gathered around a central ac-dc converter [11], [12].…”

“…Hence, another driver solution has to be found. Figure 1(b) shows an enhancement of the single-output LED driver to fix the mentioned drawbacks [11], [15]- [19]. Now, each LED string is supplied by its own output.…”