Hot Deformation Behavior and Microstructure Mechanisms of As-Cast 2219 Al Alloy

Zhang, Yun; Jiang, Ripeng; Yang, Youwen; Li, Ruiqing; Chen, Pinghu; Li, Xiaoqian; Zhang, Lihua

doi:10.1007/s11837-020-04042-6

Cited by 5 publications

(1 citation statement)

References 47 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Kaibyshev et al [ 44 ] indicated that the hot compressed 2219 Al alloy exhibits a threshold stress at 250–500 °C, and the dislocation transitions from the local slip to the cross slip with the raised temperature. Zhang et al [ 45 ] found that the broken θ particles can reduce the stress concentration and induce DRX process during deformation. Liu et al [ 46 ] modified the Arrhenius equation to determine the effects of deformation parameters on activation energy.…”

Section: Introductionmentioning

confidence: 99%

Dynamic Softening Mechanism and an Improved Unified Constitutive Model for an Al–Cu–Mn–Fe–Zr Alloy during Warm Deformation

et al. 2021

View full text Add to dashboard Cite

Deformation behavior of an Al–Cu–Mn–Fe–Zr alloy is investigated by plane strain compression tests at a warm deformation region. The flow stress first increases and then keeps steady, and the flow stress increases with reducing temperature or raising strain rate. However, the influence of strain rate on flow stress is weak at 100 and 150 °C. The dynamic recovery (DRV) mechanism is the dominant mechanism to balance the work hardening, and a larger number of dislocations are consumed at low strain rates. So, the deformed grains are difficult to reach the critical strain for dynamic recrystallization (DRX). When the strain rate is relatively high, the critical strain can be reached in a short time, which promotes the process of DRX. In addition, an improved unified constitutive model is built based on the evolution of dislocation density. The predicted flow stresses are in a close agreement with the measured results, proving that the built model can nicely reproduce the flow behavior.

show abstract

Section: Introductionmentioning

confidence: 99%