Influence of Computed Tomography Parameters on the Radiotherapy Plan Calculation

Abstract

Contouring, planning and dose calculation in treatment planning systems (TPS) are based on computedtomography (CT) images. Therefore, it is important to have developed, optimized and adapted scanning protocolsfor specific anatomic regions and special radiotherapy modalities such as stereotactic radiosurgery (SRS). The aimof this study was to determine influence of tube voltage, field of view size (FOV) and reconstruction kernels on CTnumbers and the resulting radiotherapy (RT) dose calculation.This study was performed at Clinic of Oncology, Clinical Center University of Sarajevo. Verification electrondensity and CT number values was performed using CIRS Thorax 002LFC phantom, while anthropomorphic CIRS038 phantom for stereotactic end-to-end verification was used for the purpose of dose plan calculation analysis withlarge bore CT simulator Canon Aquillion LB.The significant correlation between the tube voltage and the measuredvalues of CT numbers is significant for all materials (p < 0.05), except for water (p = 0.310). No significantcorrelation between FOV and obtained values of CT numbers was found in any of the evaluated tissue equivalentmaterials. Evaluating the impact of reconstruction kernels on Hounsfield units (HU), significant deviations werefound for the FC62, FC68 and FC07 reconstruction kernels. Also, analyzing the influence of reconstruction kernelson the RT dose calculation, the extreme values are associated with Dmin/D in PTV for kernels FC41 and FC68, wheredeviations from the values obtained using the baseline scanning parameters were -1.3% and -1.9%. For deviation of1 HU in muscle tissue of CIRS 002LFC, the calculated Dmin/D in PTV of CIRS STEEV phantom will reduce by0.79%. Similarly, the reduction of D₉₈ and D₂ would be 6.8 cGy and 3.03 cGy for 1 HU, respectively. Change of thereconstruction kernels caused differences of 0.4% in Dmin/D calculation in clinical target volume (CTV).CT scanning and reconstruction parameters may affect Hounsfield units, which could have an impact on dosecalculations in RT plan. Hence, it is recommended to standardize the scanning protocol used in calibration curvegeneration for TPS. One should avoid use of different tube voltages and kernels, while according to this study, thechange of FOV will have no impact on dose calculations