Influence of structural and textural states of low-carbon steels on the cracking resistance of tube products

Данилов, С. В.; Urtsev, N. V.; Maslennikov, K. B.; Urtsev, V. N.; Лобанов, М. Л.

doi:10.1063/5.0037045

Cited by 1 publication

(1 citation statement)

References 18 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This is apparently due to the recrystallization of α-phase resulted from the highest T CR for Route 1. For samples 2-5, the orientations resulting from the γ → α transformation are observed alongside with the orientations typical of deformed and recrystallized ferrite grains, which according to [39] correspond to {hhl}<110>-type orientations. Such orientations of the α-phase develop during controlled rolling below A C3 .…”

Section: Crystallographic Texturementioning

confidence: 99%

Tensile Deformation and Fracture Behavior of API-5L X70 Line Pipe Steel

Лобанов

Хотинов

Urtsev³

et al. 2022

Materials

View full text Add to dashboard Cite

Thermo-mechanical controlled processing (TMCP) is employed to obtain the required level of mechanical properties of contemporary HSLA steel plates utilized for gas and oil pipeline production. The strength and crack resistance of pipeline steels are mainly determined by its microstructure and crystallographic texture. In this study, the influence of the structural and textural states of industrially produced API-5L X70-X80 pipeline steels on tensile mechanical properties was analyzed. TMCP routes with different hot rolling temperatures and cooling rates were employed. The texture of steel was assessed using the Taylor factor, which was calculated based on electron backscatter diffraction (EBSD). The decrease in rolling temperature resulted in the sharper texture characterized by {001} planes banding (cleavage planes in the bcc lattice) parallel to rolling direction. The tensile deformation behavior at the stage of necking was determined by the crystallographic and morphological texture of the material and demonstrated significant anisotropy. Rupture of all investigated samples was accompanied by the development of splitting on the fracture surface. The splitting was localized in the rolling plane similar to the splitting in standard Charpy tests of pipeline steels.

show abstract

Section: Crystallographic Texturementioning

confidence: 99%