Investigation on component wall angle in single stage incremental forming of austenitic stainless steel AISI 304 sheet

Abstract

The aim of this research work is to study the effect of process parameters in achieving the maximum possible wall angle of the component in single stage incremental forming. Austenitic stainless steel AISI 304 is used as a sheet material. The constant tool rotational speed of 250 rpm, tool feed of 1000 mm/min and incremental depth of 0.5 mm were used as process parameters and the wall angle was varied from 60 o .Grid marking technique is used for strain measurements. From the results, it is observed that the maximum height of 45 mm was formed successfully at wall angles 60 o , 61 o , 63 o and 64 o without any defects within the experimented process parameters. Further increase in either the wall angle or the process parameters produced fractured component at a height of around 22 mm itself.