Jamming Modulation: An Active Anti-Jamming Scheme

Abstract

Providing quality communications under adversarial electronic attacks, e.g., broadband jamming attacks, is a challenging task. Unlike state-of-the-art approaches which treat jamming signals as destructive interference, this paper presents a novel active anti-jamming (AAJ) scheme for a jammed channel to enhance the communication quality between a transmitter node (TN) and receiver node (RN), where the TN actively exploits the jamming signal as a carrier to send messages. Specifically, the TN is equipped with a programmable-gain amplifier, which is capable of re-modulating the jamming signals for jamming modulation. Considering four typical jamming types, we derive both the bit error rates (BER) and the corresponding optimal detection thresholds of the AAJ scheme. The asymptotic performances of the AAJ scheme are discussed under the high jamming-to-noise ratio (JNR) and sampling rate cases. Our analysis shows that there exists a BER floor for sufficiently large JNR. Simulation results indicate that the proposed AAJ scheme allows the TN to communicate with the RN reliably even under extremely strong and/or broadband jamming. Additionally, we investigate the channel capacity of the proposed AAJ scheme and show that the channel capacity of the AAJ scheme outperforms that of the direct transmission when the JNR is relatively high.

Anti-Reactive Jamming Technology Based on Jamming Utilization

“…This method does not assume the spectral coverage and power of the jammer, can be applied to more scenarios. Similarly, Ma et al [20] proposed an active anti-jamming (AAJ) scheme, which re-modulates the jamming signal and transmits information using different energy levels of the jamming signal. In the jamming energy collection, Van Huynh et al [13] based on deep reinforcement learning, proposed a jamming utilization algorithm.…”