Link stability and energy aware for reactive routing protocol in mobile ad hoc network

Hamad, Sofian; Noureddine, Hadi; Al-Raweshidy, Hamed S.

doi:10.1145/2069131.2069169

Cited by 13 publications

(12 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In our previous work [24], Fixed-Link Stability and Energy-Aware (F-LSEA) protocol is suggested. In this method, the RREQ message will be forwarded only if it satisfies the link lifetime and the residual energy conditions for the transmitter nodes, according to their fixed thresholds of RE and LLT.…”

Section: Energy-aware Routing Protocolsmentioning

confidence: 99%

Average Link Stability with Energy-Aware Routing Protocol for MANETs

Hamad¹,

Belhaj²,

Muslam³

2018

ijacsa

Self Cite

View full text Add to dashboard Cite

Abstract-This paper suggests the A-LSEA (Average Link Stability and Energy Aware) routing protocol for Mobile Ad-hoc Networks (MANETs). The main idea behind this algorithm is on the one hand, a node must have enough Residual Energy (RE) before retransmitting the Route Request (RREQ) and declaring itself as a participating node in the end-to-end path. On the other hand, the Link Life Time (LLT) between the sending node and the receiving node must be acceptable before transmitting the received RREQ. The combination of these two conditions provides more stability to the path and less frequent route breaks. The average results of the simulations collected from the suggested A-LSEA protocol showed a fairly significant improvement in the delivery ratio exceeding 10% and an increase in the network lifetime of approximately 20%, compared to other re-active routing protocols.

show abstract

Section: Energy-aware Routing Protocolsmentioning

confidence: 99%

Average Link Stability with Energy-Aware Routing Protocol for MANETs

Hamad¹,

Belhaj²,

Muslam³

2018

ijacsa

Self Cite

View full text Add to dashboard Cite

show abstract

“…e.g. : Distance Sequenced Distance Vector (DSDV) [2]. Hybrid Protocol is combination of both the protocols in order to achieve higher performance.…”

Section: Routing Protocols For Manetmentioning

confidence: 99%

“…Route Reply (RREP) is sent by destination to source when route is established. The Route Error (RERR) is sent by either destination or intermediate nodes when there is no path to destination or when the link breaks in valid path to destination [2][25].…”

Section: Dsr Routing Protocolmentioning

confidence: 99%

“…In the G-info field adds the request message queue load information of the received RREQ message which is then extracted from hope count value when this RREQ is reached at the network layer. The second data structure is the RREQ_BUFFER that is created at each node during the route discovery process [2], [3]. …”

Section: Secure Multi-hop Neighbor Monitoring Mechanism Dsrmentioning

confidence: 99%

See 1 more Smart Citation

DoS Attack Prevention Technique DSR Protocol based on Signal Strength

Dhatarwal¹,

Nagar²

2017

IJCA

View full text Add to dashboard Cite

Ad Hoc network is a network that is not any fixed physical structure and is established with mobile nodes using wireless connections. Ad Hoc network is highly flexible and use dynamic network topology. Thus, the efficiency of the routing protocol will affect the all network performance. Dynamic Source Routing (DSR) is one of the extensively used routing protocols for packet transfer from source to destination. It relies on maintaining most recent information, for which, each ad-hoc node maintains hop count and sequence number field. Mobile ad hoc networks carriage many types of security problems, initiated by their open systems and nature of collaborative by limited accessibility of resources.In this paper, his propose an improved version of DSR routing protocol using neighbor monitoring Scheme which prevents dos attack and accomplishes in maintaining Integrity Security Standard by following minimum hop count path. In GDSR a neighbor monitoring has been detected the routing and packet forwarding vulnerabilities for an incoming demand that helps to stabile its security and efficiency of incoming messages. GDSR DSR routing scheme is evaluated by simulation and results show that improved FPR, throughput and ETE delay can be obtained using simulator.

show abstract

“…Sajal Sarkar et al [9] calculated trust of node by own energy factor and energy factor of node to neighbour node as observed by common neighbour node and find the path according to trust. Sofian Hamad et al [10] checked the link expiration time between two nodes when node receive the RREQ message with the predefined threshold and also check the energy of node with predefined threshold and find the better path for routing. Xu Zhen et al [11] proposed algorithm based on DSR protocol which divide the energy in to different level (normal, warn and danger) and apply different technique based on energy level.…”

Section: Introductionmentioning

confidence: 99%

Energy Efficient Ad-hoc Routing Protocol for Disaster Scenario

Patel¹,

Gondaliya²

2014

IJCA

View full text Add to dashboard Cite

Due to decentralization and infrastructure less characteristics of ad hoc networks, it can be established in any environment without pre-existing infrastructure with ease of deployment. There are many issues for designing of ad hoc network like MAC layer protocol, security, mobility of nodes, routing protocol, quality of service etc… The most challenging is design of routing protocol which may affects the performance of ad hoc network. Ad-hoc networks are very useful in disaster scenario which provides communication among rescue team members to perform relief operation efficiently. In this paper, we have proposed a new technique based on link stability and energy aware, which is applied to Ad-hoc On Demand Distance Vector (AODV) protocol. We have checked performance of normal AODV, Min max based AODV, distance based AODV and our modified AODV routing protocol in terms of routing metrics like packet delivery ratio, normalized routing load, throughput and remaining energy using NS2 simulator. Nodes in ad hoc network are having limited battery power so; if they consume battery power very efficiently then life time of nodes can be increased. From the simulation results, it is observed that our proposed technique on AODV protocol consume less energy and gives better performance than different variant of AODV.

show abstract

Link stability and energy aware for reactive routing protocol in mobile ad hoc network

Cited by 13 publications

References 5 publications

Average Link Stability with Energy-Aware Routing Protocol for MANETs

Average Link Stability with Energy-Aware Routing Protocol for MANETs

DoS Attack Prevention Technique DSR Protocol based on Signal Strength

Energy Efficient Ad-hoc Routing Protocol for Disaster Scenario

Contact Info

Product

Resources

About