Mechanism and Kinetics

Fellows, Christopher M.

doi:10.1002/9780470414811.ch3

Cited by 7 publications

(1 citation statement)

References 68 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…As shown in Table , an increase in the cross-linker fraction results in the reduction of polymer film thickness. This observation is tentatively attributed to a higher rate of quenching of the propagation reaction in case larger amounts of cross-linker are used . Ellipsometric spectra could be well-described by a simple ambient–film–substrate model, which confirms that the films are not inhomogeneous on the length scale of several tens of nanometers.…”

Section: Resultsmentioning

confidence: 64%

Synthesis of Ultrathin Poly(methyl methacrylate) Model Coatings Bound via Organosilanes to Zinc and Investigation of Their Delamination Kinetics

Iqbal

Rechmann

Sarfraz

et al. 2014

ACS Appl. Mater. Interfaces

View full text Add to dashboard Cite

Polymer coatings are widely used to protect metals from corrosion. Coating adhesion to the base material is critical for good protection, but coatings may fail because of cathodic delamination. Most of the experimental studies on cathodic delamination use polymers to study the corrosion behavior under conditions where the interfacial chemistry at the metal(oxide)/polymer interface is not well-defined. Here, ultrathin linear and cross-linked poly(methyl methacrylate) [PMMA] coatings that are covalently bound to oxide-covered zinc via a silane linker have been prepared. For preparation, zinc was functionalized with vinyltrimethoxysilane (VTS), yielding a vinyl monomer-covered surface. These samples were subjected to thermally initiated free radical polymerization in the presence of methyl methacrylate (MMA) to yield surface-bound ultrathin PMMA films of 10-20 nm thickness, bound to the surface via Zn-O-Si bonds. A similar preparation was also carried out in the presence of different amounts of the cross-linkers ethylene glycol diacrylate and hexanediol diacrylate. Functionalized and polymer-coated zinc samples were characterized by infrared (IR) spectroscopy, secondary ion mass spectrometry (SIMS), ellipsometry, and X-ray photoelectron spectroscopy (XPS). Coating stability toward cathodic delamination has been evaluated by scanning Kelvin probe (SKP) experiments. In all cases, the covalently linked coatings show lower delamination rates of 0.02-0.2 mm h(-1) than coatings attached to the surface without covalent bonds (rates ∼10 mm h(-1)). Samples with a higher fraction of cross-linker delaminate slower, with rates down to 0.03-0.04 mm h(-1), compared to ∼0.3 mm h(-1) without cross-linker. Samples with longer hydrophobic alkyl chains also delaminate slower, with the lowest observed delamination rate of 0.028 mm h(-1) using hexanediol diacrylate. For the coatings studied here, delamination kinetics is not diffusion limited, but the rate is controlled by a chemical reaction. Several possibilities for the nature of this reaction are discussed; radical side reactions of the oxygen reduction are the most likely path of deadhesion.

show abstract

Section: Resultsmentioning

confidence: 64%