Melt characteristics, mechanical, and thermal properties of blown film from modified blends of poly(butylene adipate‐co‐terephthalate) and poly(lactide)

Abstract

Blown films from poly(butylene adipate-coterephthalate) and poly(lactide) (PLA) blends were investigated. The blends were prepared in a twin-screw extruder, in the presence of small amounts of dicumyl peroxide (DCP). The influence of DCP concentration on film blowing, rheological, mechanical, and thermal properties of the blends is reported in this article. Rheological results showed a marked increase in polymer melt strength and elasticity with the addition of DCP. As a consequence, the film homogeneity and the stability of the bubble were improved. The modified blend films, compared with the unmodified blend, showed an improvement in tensile strength and modulus with a slight loss in elongation.Fourier transform infrared and gel results revealed that chain scission and branching were more significant than crosslinking when the DCP loadings in the blends were not higher than 0.7%. A reduction in melt temperatures of PLA was observed due to difficulty in chain crystallization. The concentrations of DCP strongly affected the melting temperatures but had an insignificant effect on the decomposition behavior of the blends. V C 2011 Wiley Periodicals, Inc. J Appl Polym Sci 124: [4986][4987][4988][4989][4990][4991][4992] 2012

A new approach for flexible PBAT/PLA/CaCO3 films into agriculture

“…However, the mainly obtained products are the formation of stable chain‐ends with carbonyl and hydroxyl groups or reactive end groups . The stable chain‐ends can efficiently perform hydrogen bonds with PLA and PBAT polymer chains, while the reactive chain‐ends can generate crosslinked structures between the polymers also and increase the compatibility …”

Enhanced Film Blowing of Polylactide by Incorporating Branched Chains and Stereocomplex Crystals

“…Based on the literature, commercial PLAs have avery narrow stable production window which is due to their linear chain structure and lack of strain hardening. To our knowledge, only few studies have dealt with improving stability and operating window of pure PLA film blowing process and most of the research work have focused on processing of PLA blends with other materials or enhancement of final film properties (Sirisinha and Somboon, 2012;Mallet et al, 2014) .Enhanced orientation in film blowing process was employed to increase barrier properties of PLA/layered silicate nanocomposite films. Oriented clay platelets in PLA films were shown to decrease oxygen and water vapor permeability up to 50 %and CO 2 permeability up to 80 % ( Thellen et al, 2005;Zenkiewicz et al, 2010).…”

Reactive modification and compatibilization of poly(lactide) and poly(butylene adipate‐co‐terephthalate) blends with epoxy functionalized‐poly(lactide) for blown film applications

“…Isocyanates undergo the chain extension reaction readily however their toxicity greatly limits their use, especially in films, where a major application is food packaging . Peroxide chain extenders also have been shown effective at increasing the rheological properties, however their high reactivity causes gels at concentrations as low as 0.7 wt % . Multifunctional epoxy polymers (MEP) can function as rheology modifiers through reaction of the carboxyl and/or hydroxyl groups with the epoxy groups of MEP.…”

“…Literature reports the use of MEP for compatibilizing PLA/PBAT blends, resulting in improved mechanical properties . However, very few papers report the use of these materials for blown film applications . As discussed earlier, EF‐PLA is a highly effective rheology modifier of PLA.…”